Miller SpectrumICE-40T Torch Kullanıcı El Kitabı - Sayfa 16
Kaynak Sistemi Miller SpectrumICE-40T Torch için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller SpectrumICE-40T Torch 44 sayfaları. Air plasma cutter
Sayfayı Yazdır
4-2. Duty Cycle And Overheating
For Units Connected to a 208 Volt Circuit or a 230 Volt Circuit:
50% Duty Cycle At 40 amperes, 140 volts DC (typical cutting)
5 Minutes Cutting
Overheating
4-3. Power Source Dimensions And Weight
Dimensions And Weight
24 lb (10.9 kg)
including torch
4-4. Torch Dimensions And Weight
3.5 lb (1.6 kg) w/20 ft (6.1 m) Cable
OM-237 974 Page 12
.
A complete Parts List is available at www.MillerWelds.com
0
15
Minutes
13-1/8 in.
(333 mm)
1 in.
(25 mm)
1-3/8 in.
(35 mm)
5 Minutes Resting
Reduce Duty Cycle
5-1/2 in.
(140 mm)
9 in.
(229 mm)
8-3/8 in.
(213 mm)
Duty Cycle is percentage of 10 min-
utes that unit can cut at rated load
without overheating.
If unit overheats, thermostat(s)
opens, output stops, Temperature
trouble light goes On, and cooling
fan runs. Wait fifteen minutes for
unit to cool or temperature light to
go off. Reduce amperage or duty
cycle before cutting or gouging.
NOTICE − Exceeding duty cycle
can damage unit or gun and void
warranty.
A
OR
sduty1 5/95 / Ref. 805 325-A
!
Do not move or operate unit
where it could tip.
loc_2 3/96 - Ref. 805 325-A
Ref. 802 877