Miller Spoolmate 3035 Kullanıcı El Kitabı - Sayfa 19
Kaynak Sistemi Miller Spoolmate 3035 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller Spoolmate 3035 36 sayfaları. Wire feeder spool gun
Ayrıca Miller Spoolmate 3035 için: Kullanıcı El Kitabı (28 sayfalar), Kullanıcı El Kitabı (28 sayfalar)
Sayfayı Yazdır
2-9. Installing Wire Spool And Threading Welding Wire
Tools Needed:
5
9
10
Press gun trigger to feed wire to check drive roll
pressure. Turn screw enough to prevent slipping.
7
6
8
3
Remove nozzle and contact tip. Push
and hold red lever. Thread wire through
inlet guide, past push roll/drive roll, and
out end of gun 2 inches (50 mm).
Install contact tip and nozzle. Reinstall
spool cover and thumb screw.
.
Screw rotation clockwise decreases
drive roll pressure and counterclockwise
rotation increases pressure.
Wood
1
Thumb Screw
2
Spool Cover
Remove thumb screw and spool
cover.
3
Hub Tension Nut
4
Wire Spool
Install spool so wire feeds from top.
Turn hub tension nut just so a slight
4
drag is felt on the wire spool.
5
Push Roll/Lower Drive Roll
2
6
Drive Roll Pressure
Adjustment Opening
7
Drive Roll Release Lever
1
(Red)
8
Wire Inlet Guide
9
Contact Tip
10 Nozzle
Release red lever.
Turn On welding
power source power.
Cut off wire.
Ref. 801 891-A
OM-1216 Page 15