Miller SuitCase X-TREME 12VS Kullanıcı El Kitabı - Sayfa 29
Kaynak Sistemi Miller SuitCase X-TREME 12VS için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller SuitCase X-TREME 12VS 44 sayfaları. Ce and non-ce models
Sayfayı Yazdır
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
n = Check
Z = Change
Every
3
Months
n Z l
n l
Every
6
Months
n ~
7-2. Overload Protection And Thermostat Protection
Internal Side View
!
~ = Clean
l = Replace
Replace
Damaged
Or
Unreadable
Labels
Clean
Drive
Rolls
CB1
.
Disconnect power
before maintaining.
n l
n ~
!
1
CB1 protects wire feeder from over-
1
load. Correct problem and reset
CB1.
Close and latch door.
Thermostat Protection
Unit has internal thermostat protec-
tion and will not feed wire if over-
heating occurs (see Section 7-4).
Maintain more often during
severe conditions.
Replace
Damaged Gas
Hose
Repair Or Replace
Cracked Cables And
Cords
Blow Out Or
Vacuum Inside
Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
Supplementary Protector CB1
Ref. 256 618-A
OM-252203 Page 25