Miller XMS 403 Kullanıcı El Kitabı - Sayfa 14

Kaynak Sistemi Miller XMS 403 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller XMS 403 44 sayfaları. 400 volts ce arc welding power source

Sayfayı Yazdır

3-5. Volt-Ampere Curves

3-6. Installing Turntable for Wire Feeder on Power Source (Optional)

OM-244 243 Page 10

A. CC Mode

ARC CONTROL

B. CV Mode

Volt-ampere curves show minimum

and maximum voltage and amper-

age output capabilities of unit.

Curves of other settings fall be-

tween curves shown.

va_curve1 4/95 − SA-178 652 / SA-178 653

Turn off welding power

source and disconnect in-

put power before proceed-

ing.

Remove wire spool.

Turntable

Screw

Remove the 4 screws and the plas-

tic cap on the power source upper

cover and keep them for future use.

Insert the turntable in the upper hole

and secure with 4 screws. Be sure

screws are tight.

If desired, install the wire feeder on

the turntable using the hole in the

bottom of the feeder.

Ref. 956142645-5-5