Miller AFT-100 Kullanıcı El Kitabı - Sayfa 11

Kaynak Aksesuarları Miller AFT-100 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller AFT-100 24 sayfaları.

Sayfayı Yazdır

Install new contact tube.

Reinstall the nozzle and extension if applicable.

Reconnect air supply to flux tank.

Resume operation.

5-5.

CHANGING WIRE SIZE (Figure 5-1)

WARNING: ELECTRIC SHOCK can kill; FLY-

ING FLUX PARTICLES can puncture eyes

and skin; WELDING WIRE can cause punc-

ture wounds.

•

Do not touch live electrical parts.

•

Shut down welding power source and wire

feeder and be sure they cannot be accidental-

energized

components.

•

Close air valve, bleed pressure from tank,

and disconnect air supply.

•

Do not point gun toward any part of the body,

any conductive surface, or other personnel.

To change the size of the electrode wire, the only gun

part necessary to change is the contact tube. It may be

necessary to change the wire feeder inlet wire guide –

see wire feeder Owner's manual for information.

IMPORTANT: Whenever the electrode wire size is

changed, blow out both the monocoil liner and monocoil

casing with compressed air.

Remove the nozzle and extension if applicable.

6-1.

GENERAL

WARNING: ELECTRIC SHOCK can kill; FLY-

ING FLUX PARTICLES can puncture eyes

and skin; WELDING WIRE can cause punc-

ture wounds.

•

Do not touch live electrical parts.

•

Shut down welding power source and wire

feeder and be sure they cannot be acciden-

tally energized before inspecting, maintain-

ing, or servicing gun.

•

Close air valve, bleed pressure from tank,

and disconnect air supply.

•

Do not point gun toward any part of the body,

any conductive surface, or other personnel.

before

working

SECTION 6 – TROUBLESHOOTING

Cut off any portion of the electrode wire which ex-

tends beyond the end of the contact tube.

Remove the contact tube.

Retract remaining electrode wire onto wire spool.

CAUTION: FLYING DIRT AND METAL PAR-

TICLES can injure personnel and damage

equipment.

•

Point gun liner only in a safe direction away

from personnel and equipment when clean-

ing with compressed air.

Blow out gun casing or liner with compressed air

whenever the wire or liner is removed.

gun

Install the appropriate contact tube.

Reinstall the nozzle and extension if applicable.

Make necessary changes to wire feeder to ac-

commodate new wire size.

Thread new size electrode wire (see wire feeder

Owner's Manual).

10.

Reconnect air supply to flux tank.

11.

Resume operation.

5-6.

REGULATOR MAINTENANCE

The dryer contains silica desiccant to dry excess mois-

ture coming from the filter regulator. Check the color

code located on the metal bowl for the condition of the

desiccant. Replace when necessary.

Troubleshooting to be performed only by qualified

persons.

It is assumed that the unit was properly installed accord-

ing to Section 3 of this manual, the operator is familiar

with function of controls, the unit was working properly,

and that the trouble is not related to the welding process.

The following chart is designed to diagnose and provide

remedies for some of the troubles that may develop in

this unit.

Use this chart while performing troubleshooting proce-

dures. If the trouble is not remedied after performing

these procedures, the nearest Factory Authorized Ser-

vice Station/Service Distributor should be contacted. In

all cases of equipment malfunction, the manufacturer's

recommendations should be strictly followed.

OM-1542 Page 7