Miller FieldPro Remote Kullanıcı El Kitabı - Sayfa 5

Kaynak Aksesuarları Miller FieldPro Remote için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller FieldPro Remote 8 sayfaları.

Sayfayı Yazdır

CHECK POLARITY

Indicator

STICK NEGATIVE

Indicator

NOTICE − Controls on the FieldPro Remote are NOT adjustable during welding. To make adjustments during welding, use the power source controls.

Adjustments can be made if using the RHC-14 remote or wireless remote.

Table 6-1. Recommended Process Selections vs Electrode Type

Electrode Type

Routine Maintenance

n = Check

Every

Months

l Unreadable Labels

Remote Diagnostics Help Codes

Display Code

H01

H02

H03

Secondary Circuit Over Temperature

H04

Primary Temperature Sensor Malfunction

H05

The CHECK POLARITY text will illuminate along with an error message (Err) if the work and electrode leads are

reversed. This will light only if a FieldPro accessory is connected. Power down and correct the connections (see

Section 4 for proper connections).

The DCEN (−) STICK NEG text will illuminate if the polarity is negative while in STICK mode. To activate DCEN

mode, press the STICK button and down arrow at the same time. Press the STICK button to exit this mode. The

DCEN mode can be used for EXX10 and/or EXX18 process setting. The mode has to be set for each electrode

process individually.

EXXX1

EXXX2

EXXX3

EXXX4

EXXX5

EXXX6

EXXX7

EXXX8

Stainless

~ = Clean

l = Replace

~ Weld Connections

Display Example

Fault

Primary Transformer Over Current

Secondary Thermistor Malfunction

Primary Circuit Over Temperature

Suggested Process Setting

Disconnect power before maintaining.

n Tighten Weld Connections

Indicates a malfunction in the primary power circuit. If this code

appears on the display, contact the nearest Factory Authorized

Service Agent.

Indicates the left side thermal protection circuitry is

malfunctioning. If this code appears on the display, contact the

nearest Factory Authorized Service Agent.

Indicates left side of unit has overheated. Unit has shutdown to

allow fans to lower left side temperature. Operation will continue

after unit is within normal temperature range.

Indicates the right side thermal protection circuitry is

malfunctioning. If this code appears on the display, contact the

nearest Factory Authorized Service Agent.

Indicates right side of unit has overheated. Unit has shutdown

to allow fans to lower right side temperature. Operation will

continue after unit is within normal temperature range.

EXX10

EXX18

nl Weld Cables And Cords

Description

OM-257 886 Page 5