Miller PipeWorx 350 Kullanıcı El Kitabı - Sayfa 15

Kaynak Aksesuarları Miller PipeWorx 350 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller PipeWorx 350 32 sayfaları.

Sayfayı Yazdır

5-1. Selecting A Location

Movement
1
OR
Location And Airflow
18 in.
(460 mm)
Loc_rack2 2018-08

5-2. Lifting/Moving The Equipment

2
SECTION 5 − INSTALLATION
7 ft (2.1 m)
minimum length
1
!
Do not move or operate unit
where it could tip.
2
3
18 in.
(460 mm)
7 ft (2.1 m)
minimum length
1
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
1
Lifting Eye
2
Lifting Forks
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
3
Line Disconnect Device
Locate unit near correct input
power supply.
!
Lift only from the lifting eyes
located at the top of the unit.
Be sure location is clear of all
obstructions, including util-
ity lines and roof overhangs.
1
Lifting Eyes
Use lifting eyes to move unit.
2
Lifting Forks
If using lifting forks, be sure forks
are fully inserted.
Movement
.
Rated Capacity For Lifting Eyes:
1500 lb (680 kg)
This rating is for the lifting
method shown above using both
lifting eyes. DO NOT use just
a single lifting eye to move unit.
801 697-C
OM-259463 Page 11