Miller Travel Master SB-10D Kullanıcı El Kitabı - Sayfa 16

Kaynak Aksesuarları Miller Travel Master SB-10D için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller Travel Master SB-10D 44 sayfaları. Automatic welding sidebeam

Sayfayı Yazdır
5.
Use Figure 4-1 to locate leads 1, 2, and 3 from the
triple-pole, single-throw switch.
IMPORTANT: The switch leads are not numbered. The
leads are referred to as leads 1, 2, and 3 in Figure 4-1 to
simplify installation.
6.
Install lead 1 to terminal A of terminal strip 2T.
7.
Use Table 4-2 to install leads 2 and 3 to appropri-
ate terminals of terminal strip 1T.
8.
Locate receptacle RC10 on component mounting
panel on rear panel of unit. Connect one of the re-
maining leads to 3/16 in. friction terminals at ter-
minal X of RC10.
(Between Automatic Weld Control And Customer-Supplied Switch)
Automatic Weld
Control Model
1A
1DA
1DA-PS
*Terminal connections located on either terminal strip 1T or terminal strip 2T in weld control.
Five-Conductor Cord
Refer To Table 4-2
For Connections To
AUTOMATIC Weld Control
To Terminal X On RC10
Connections
To Terminal V On RC10
To
AUTOMATIC
Weld Control
To Terminal F On RC4
To Terminal H On RC4
Figure 4-1. Skip Welding Switch Connections (Triple-Pole Single-Throw Switch)
OM-889 Page 12
Table 4-2. Skip Welding Connections
Remove Jumper Link
Between These Terminals*
G and H on 1T
E and F on 1T
F and G on 1T
Lead 1
Lead 2
Lead 3
9.
Route the four-conductor cord from Step 1
through the strain relief clamp on the right side of
the weld control, and splice one lead from the
four-conductor cord to the remaining lead from
the five-conductor cord.
10.
Connect one of the three remaining leads from
the four-conductor cord to terminal V on recep-
tacle RC10.
11.
Locate receptacle RC4 on component mounting
panel on rear panel of unit. Connect the two re-
maining leads to 3/16 in. male friction connectors
at terminals F and H on receptacle RC4.
12.
Tighten strain relief clamp, and close and secure
access door.
Switch-To-Terminal Strip Connections*
Lead 1
A on 2T
A on 2T
A on 2T
Triple-Pole, Single-Throw Switch
Four-Conductor Cord
Lead 2
Lead 3
G on 1T
H on 1T
E on 1T
F on 1T
F on 1T
G on 1T
To Terminal D On 1T
To Terminal J On 1T
Connections
To Terminal L On 1T
To Terminal J On 1T
To
Carriage
Control
SA-122 745