Miller 1034 Operatör El Kitabı - Sayfa 4

Kamera Aksesuarları Miller 1034 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Miller 1034 12 sayfaları. Fluid head

Sayfayı Yazdır

Introduction

Thank you for purchasing the Compass 15 Fluid Head. The

Compass 15 Fluid Head has been designed to suit payload

capacities from HDV to standard configuration DVCAM cameras.

The robust design and construction of the Compass 15 Fluid Head

offers maximum stability, accuracy and durability and includes

precision ball bearing mounted Fluid Drag Plate system in the Pan

and Tilt assembly to deliver true fluid drag performance over the

entire temperature and payload range.

The Fluid Drag and the Counterbalance system were designed to

provide excellent control and repeatability and offer progressive

equal increments of drag and torque.

The Compass 15 Fluid Head also offers Illuminated Bubble level.

The Compass 15 Fluid Head will give best performance when

used on a wide range of Miller tripods, including SOLO DV

(#1501 & 1630) and Lightweight (#440 & 420) tripod. This will

ensure maximum system stability to suit any professional set-

up. The Compass 15 Fluid Head will suit most industry standard

75 mm tripods as well, please refer to manufactures' manual for

mounting details.

Safety Instructions

Attaching/removing the camera.

Please use this manual to familiarise yourself with the operation

of the Compass 15 Fluid Head and observe these instructions

to prevent any damage to your equipment. Ensure that all

equipment is operating correctly and free from defects and

damage, also please ensure that the tripod is steady, secure and

that the bowl is approximately horizontal when attaching the

camera. The operator is responsible for the safe operation of this

piece of equipment.

•

Do not exceed the maximum payload capacity of

the Fluid Head.

•

Do not leave the camera unattended on the Fluid Head.

•

Do not release the SLIDING PLATFORM LOCK whilst the

camera is at an angle.

•

Do not adjust the tripod whilst the camera is attached

to the Fluid Head.

•

Ensure PAN HANDLE CLAMP and CLAMP NUT

is securely tightened.

•

Apply TILT LOCK when adding/removing equipment from the

camera or when attaching/removing the camera from

the Fluid Head.

•

Hold camera securely whilst changing Counterbalance,

Pan Drag or Tilt Drag settings.

•

Hold the camera securely whilst releasing the

RELEASE KNOB.

•

Hold camera securely whilst adjusting the CLAMP NUT

to level the Fluid Head.