Miller 1038 Operatör El Kitabı - Sayfa 7

Kamera Aksesuarları Miller 1038 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Miller 1038 12 sayfaları. Fluid head

Operating Instructions

C a m e r a S e t - u p .

2.1 Remove the CAMERA PLATE by pulling down the SAFETY

TAB while rotating the QUICK RELEASE KNOB to the left.

The CAMERA PLATE should pop out.

2.2 Refer to the Camera's owners manual for correct method of

attachment to the CAMERA PLATE. Inspect the CAMERA

PLATE and remove the 1/4" and 3/8" screws or the 1/4" +

PIN CARRIAGE (DVCAM mount) as required. The 1/4" and

3/8" screws can be stored underneath the SLIDING

PLATFORM (fig. 1).

2.3 Attach camera accessories and the battery to the camera, it

is recommended to estimate the camera's Centre of Gravity

(C of G) for the purpose of correctly positioning the camera

on the CAMERA PLATE. The camera's C of G can be

estimated by placing the camera on to a round rod and then

shifting it backwards or forwards until a balance point – C of

G - is achieved. It is recommended to identify this point on

the camera as it will be useful in step 2.5.

2.4 Attach the CAMERA PLATE to the camera or the QUICK

RELEASE TRIPOD ADAPTOR and securely tighten the

screws.

2.5 Align the CAMERA PLATE with the SLIDING PLATFORM

and slide it in until the safety mechanism is engaged.

2.6 Release the SLIDING PLATFORM LOCK and slide the

SLIDING PLATFORM such that the camera's C of G is

directly above the centre axis of the Fluid Head and tighten

the SLIDING PLATFORM LOCK (fig.5). If this can not be

achieved then reposition the CAMERA PLATE on the

Camera or the QUICK RELEASE TRIPOD ADAPTOR –

step 2.4. This will ensure that the system has maximum

stability

C of G

Fig. 5

Sliding Paltform

Sliding

Platform

Lock