Miller 1092 Compassx 6 1093 Operatör El Kitabı - Sayfa 4
Kamera Aksesuarları Miller 1092 Compassx 6 1093 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Miller 1092 Compassx 6 1093 13 sayfaları. 16 cb plus fluid head compassx series
Sayfayı Yazdır
Operating Instructions
2. Mounting Your Camera
2.1 Remove the CAMERA PLATE by lifting the SAFETY
RELEASE LEVER on the PLATFORM (SLIDE LOCK LEVER
must be unwound (clockwise)) (Fig. 3a).
2.2 Attach the CAMERA PLATE to the camera
the Centre of Gravity (C of G)
approximately in the middle of the camera plate.
2.3 Tighten PAN/TILT LOCKS, mount the CAMERA PLATE
to the PLATFORM non-locking side first. The side load
lock mechanism will capture camera plate (distinct click
sound will be made when CAMERA PLATE is retained).
CAMERA PLATE will be able to slide freely (60mm) until
SLIDE LOCK LEVER is tightened.
2.4 Untighten TILT LOCK, slide the CAMERA PLATE such
that the camera's C of G is directly above the centre axis
of the Fluid Head (fig. 3b), camera should be balanced (if
not slide camera backward or forward). Once balanced
tighten the SLIDE LOCK LEVER (anti-clockwise)
tighten TILT LOCK.
If this cannot be achieved then reposition the CAMERA
PLATE on the Camera – step 2.2.
NOTES:
Refer to the camera's owners manual for correct method of
1
attachment to the CAMERA PLATE. Remove the 1⁄4" screw
or 3/8" screw as required.
2
The camera's C of G can be estimated by placing the
camera on to a round rod and then shifting it backwards
or forwards until a balance point – C of G - is achieved. It is
recommended to identify this point on the camera as it will
be useful in step 2.2.
Ensure SLIDE LOCK LEVER is tightened at all times when
3
you are not finding C of G or mounting/dismounting camera.
such that
1
mark on the camera is
2
and
3
4
Slide Lock Lever
Safety Release Lever
C of G
Platform
Tilt Lock
Pan Lock
Fig. 3a
Centre Axis
Fig. 3b