Miller 1505 Solo VJ Operatör El Kitabı - Sayfa 4

Kamera Aksesuarları Miller 1505 Solo VJ için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Miller 1505 Solo VJ 8 sayfaları. 3-stage tripod 100mm tripod series

Sayfayı Yazdır

Remove tripod from carry bag, undo clip on leg strap and

stand on a level surface (if possible). Depending on

surface, screw out rubber foot for non-scratch contact

to interior or hard surfaces or in for a spike on exterior

soft surfaces such as dirt or sand.

Note: Leg angle adjusters are spring loaded and self

adjusting. Do not hold leg angle adjuster up while spreading

tripod legs as this may cause leg angle adjusters to operate

improperly and potentially damage the tripod.

Maximum Height:

(Leg angle adjustment is not required)

1 Separate legs slightly so they are

parallel.

2 Working with each leg individually,

grip each concentric lock and

release one turn (see leg lock

direction label on leg).

3 Extend to desired length and

turn each concentric lock to

engage firmly. Repeat

process for remaining legs.

4 Spread tripod legs (Fig. 2)

and adjust leg length to

ensure tripod bowl is

approximately level.

5 Level the fluid head using bubble level and ball

levelling feature of fluid head.

Minimum Height:

Note: It is recommended that

minimum height position is used only

with legs at their shortest length.

1 Pull up leg angle adjuster until it locks into a raised

position (Fig. 3). Repeat for all three locks.

2 Holding one leg on the ground pull the remaining two

outward, spreading the tripod to its lowest position. Leg

angle adjuster will automatically engage the leg to hold

the tripod at its lowest

height position (Fig. 4).