Miller Cool Belt Kullanıcı Kılavuzu - Sayfa 8

Motosiklet Aksesuarları Miller Cool Belt için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Miller Cool Belt 22 sayfaları. Auto-darkening helmets helmet cooling system

Sayfayı Yazdır

1. Helmet Cooling System Specifications

3-2. Installing Headgear And Shroud

Use bottom hole for

quick release Elite

and Titanium hel-

mets. Use top hole

for all other helmets.

OM-235 368 Page 6

Remove knobs, o−rings, and

washers

headgear. Remove headgear.

Use supplied towelette to clean

area inside helmet where Vel-

cro® will be installed. Allow

cleaned area to dry.

Remove backing from Velcro.

Install Velcro strip 5/8 in. (1.5

cm) from edge of quick release

Elite and Titanium helmets. For

all other helmets, install Velcro

3/4 in. (2 cm) from edge of hel-

met.

Position

headgear in helmet. Install

headgear mounting screw in

headgear bottom hole (quick re-

lease Elite and Titanium hel-

mets) or top hole (all other hel-

mets).

Secure headgear with knobs,

o−rings, and washers.

Align Velcro on shroud with Vel-

cro strip inside helmet. Press the

Velcro surfaces securely to-

gether.

Check for gaps between shroud

and helmet. Reposition shroud

and Velcro if necessary.

After installing shroud,

make sure there are no

gaps between shroud and

helmet edge.

Standard Headgear

Velcro Strip

Cooling System Headgear

Shroud

Velcro On Shroud

from

cooling

Remove shroud from hel-

met when using helmet with

the cooling system turned

off.

Ref. 231 425 / Ref. 804 111

standard

system