Miller XT30C Manuel - Sayfa 22

El feneri Miller XT30C için çevrimiçi göz atın veya pdf Manuel indirin. Miller XT30C 40 sayfaları.
Ayrıca Miller XT30C için: Kullanıcı El Kitabı (40 sayfalar)

Sayfayı Yazdır
Miller XT30C Manuel

4-5. Installing 40 Ampere (XT40) Torch And Work Cable On Spectrum 625 X-TREME

(Stock No. 907 404 And 907 531), And Using Trigger Safety Lock

6 4 5
7
2
1
6
5
4
3
Trigger Locked
Tools Needed:
Torx 25
1/4 in
OM-254 449 Page 18
8
3
2
Trigger Unlocked
9
!
Check
DC
bus
voltage
according to Owner's Manual,
and be sure voltage is near
zero before touching any
parts.
If torch or work cable needs to be
removed or replaced, proceed as
follows:
Turn power Off, and disconnect
input power plug from receptacle.
Remove wrapper from unit (see
Owner's Manual).
Torch Connections
Remove existing torch cable from
unit.
1
Strain Relief
Loosen strain relief screw.
2
Torch Cable
Insert cable through strain relief,
but do not tighten.
3
Air Line Connector
Insert air line connector into
solenoid fitting. Pull slightly on torch
to set fitting.
4
Plug PLG1/Receptacle RC4
Connect PLG1 from torch to
receptacle RC4 on end of wiring
harness connected to circuit board
PC1.
5
Ring Terminal And TORCH
WHITE Terminal
Connect ring terminal on end of
white leads to TORCH WHITE
terminal.
6
Ring Terminal And TORCH
RED Terminal
Connect ring terminal on end of red
leads to TORCH RED terminal.
Tighten strain relief screw.
Work Cable Connections
Remove existing work cable from
unit.
7
Strain Relief
Loosen strain relief screw.
.
Be sure to allow some work
cable slack inside the unit.
Insert work clamp lead through
strain relief, but do not tighten.
8
Work Lead Ring Terminal And
WORK BLACK Terminal
Connect ring terminal on end of
work clamp lead to terminal labeled
WORK BLACK terminal. Route
lead along torch lead bundle.
Tighten strain relief screw.
Reinstall wrapper.
9
Trigger
805 327-A / Ref. 802 860 / Ref. 253554-A