Miller Invision 352 MPa Auto-Line CE Kullanıcı El Kitabı - Sayfa 30
İnvertör Miller Invision 352 MPa Auto-Line CE için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller Invision 352 MPa Auto-Line CE 44 sayfaları.
Ayrıca Miller Invision 352 MPa Auto-Line CE için: Kullanıcı El Kitabı (48 sayfalar), Kullanıcı El Kitabı (44 sayfalar)
Sayfayı Yazdır
6-2
Configuration Option Menu (Continued)
OM-246193 Page 26
.
A complete Parts List is available at www.MillerWelds.com
AUTO
PULS
ARCL
PULS
WFS
INFO
EXIT
PULSED MIG Manual/Auto Control
This option sets the PULSED MIG control as
manual (PULS MAN) or Auto (PULS AUTO)
operation. When set to manual operation, the
arc length setting on power source and wire
speed setting on wire feeder need to be ad-
justed independently to achieve the desired arc
length. When set to Auto operation, once arc
length is determined it is not necessary to
change the arc length value with changes in
wirefeed speed.
The Invision 352 MPa and S-74 MPa are syn-
ergic allowing single knob control of the arc. As
wirefeed speed is increased or decreased, the
pulse parameters increase or decrease match-
ing the power output to the wire speed.
.
PULSED MIG Adjustment
This option allows adjusting the Pulsed MIG
process in units of Arc Length (PULS ARCL) or
preset voltage (PULS VOLT).
.
Wire Feed Speed And Wire Diameter Units
IPM
WFS IPM:
WFS is displayed in inches per minute
Diameter is displayed in inches
WFS MPM:
WFS is displayed in meters per minute
Diameter is displayed in millimeters
Revision Information
NO
This option identifies the unit's weld library
(INFO LIB) and firmware revision (INFO REV).
Press the Setup Button while the unit is display-
ing INFO LIB to identify the unit's weld library.
Press the Setup Button while the unit is display-
ing INFO REV to identify the unit's firmware re-
vision.
Pressing the Setup Button while the unit is dis-
playing INFO NO will move to the next configu-
ration option.
Exit Configuration Option Menu
NO
Press the Setup Button while the unit is display-
ing EXIT NO to return to the first configuration
option. Press the Setup Button while the unit is
displaying EXIT YES to exit the Configuration
Option Menu.
.
Auto Operation will only work with the S-74
MPa wire feeder. All other wire feeders will
only operate as manual control.
Even when Auto is displayed, operation
will be manual when any other feeder is
connected.
In PULS AUTO operation adjustments can
only be made in units of arc length.
The Configuration Option Menu can be ex-
ited at any time by turning the unit off. Only
if the unit is turned off after EXIT NO is dis-
played will configuration option changes
be saved.