AquaPRO PRO100120 Kullanıcı El Kitabı - Sayfa 4

Üfleyici AquaPRO PRO100120 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AquaPRO PRO100120 8 sayfaları. Spa blower
Ayrıca AquaPRO PRO100120 için: Kullanıcı El Kitabı (4 sayfalar)

Sayfayı Yazdır

Operating Instructions

Hartford Loop required if Blower is more

than 25 feet away from pool / spa

Alternate location for check valve if

Harford Loop is used

Grade

12 inch minimum

Figure 1

Installation

Guidelines

(Continued)

blower to the supply line. Glue fumes

can potentially cause an explosion

when the blower starts. Install a 1/4"

self-tapping screw to secure the joint if

necessary.

blower below water level. Blower

must be at least one foot above the

maximum water level.

4. Mount blower in a vertical position

using vertical rigid PVC pipe as

shown in Figure 1. For additional

support use supplied bracket as

shown in Figure 1. For warm

climates, try to locate the blower in

a shaded location.

is to be installed more than 25 ft from

the spa, it will be necessary to install a

loop that is 1 foot above the water line

and as close to the spa as possible (See

Figure 1).

check valve must be installed at least

1-877-AQUASYS

5 Foot minimum from water

(use non-metallic plumbing)

Non-metallic

electrical tubing

Mount using rigid PVC pipe. For additional support, use supplied bracket as shown.

one foot above the water level when

supercharging water jets.

5. Verify plumbing is free of leaks

Do not

before adding water to spa.

glue the

6. Do NOT install adjustable jets.

Adjustable jets can cause excessive

back pressure within the unit.

7. Hydrotherapy jets naturally aerate

when installed correctly. Do not use

Do not

install

blower to supplement aeration

when jets have been installed

incorrectly.

Wiring Guidelines

wiring instructions, could result in

death or serious injury.

If the

and electrical connections must be

blower

performed by a qualified electrician.

Installations must be in accordance

with local and national codes.

1. For electrical ratings, see product

decal.

2. Check the line voltage to make

A loop

and a

certain it is correct for the blower

being used. Do not attempt to

Conduit box and cover

24 inches above

surrounding

grade / 12 inch

minimum above

water

Air flow

Failure to

observe

All

wiring

Orient blower

housing as shown

Bracket

Check valve

(location when

NOT using a

Hartford Loop)

Rigid PVC pipe

connect 240 VAC to a 120-volt

blower; it will damage the blower

and void the warranty.

3. Refer to the National Electric Code

Guidelines for wire size and to

prevent electric shock.

4. Refer to the National Electric Code

Guidelines for proper selection of

wiring conduit and strain relief.

5. The blower field-wiring box is

designed for non-metallic electrical

tubing only. Refer to the National

Electric Code Guidelines for proper

selection of wiring, and strain

relief.

6. Be certain to connect the green

ground wire supplied with the

blower to the ground from

your electrical panel.

7. Connect remaining line wires

individually to the remaining wires

in the blower.

8. When wiring is complete carefully

install gasket and conduit cover

plate.

Overheating, short-circuiting and fire

damage will result from inadequate

wiring.

www.aquaprosystems.com

Wall or post