Burley 1800 Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 5

Kapalı Şömine Burley 1800 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Burley 1800 8 sayfaları. Electric fire

· Holding the glass in place, carefully stand the appliance up.

· Adjust the position of the glass so it sits in front of the stops near the front of the orange shell.

· Holding the glass, gently tip the appliance forward and shake a little to distribute the coals behind the

glass evenly across the orange shell.

· Using the small tool included, carefully lift the glass and move it forward so that it sits in front of the

glass stop.

· Secure the appliance as below.

Securing the appliance

For stability you must fix the fire into position using the fixing kit. This is to ensure that the appliance will not

fall forward. It is not usually necessary to have the wire taut.

Using the supplied rawlplug, attach the eye-bolt to the wall or the back of the fireplace behind the fire. Ensure

that you are not drilling or screwing into a cable or pipe. If you are not qualified to carry out this task hire a

professional.

Slacken the screw (with the washer on it) on the top of the fire – see diagram. Wrap one end of the wire half

way around the screw and tighten so the wire is trapped between the washer and the chassis. Now pass the

other end of the wire through the eye bolt. Slacken the other fixing screw on the top of the fire, position the

fire then pull the wire through to take up the slack. Wrap the wire half way around the screw and tighten to

trap the wire between the washer and the chassis. Check the fixing by tipping the fire forwards and giving it a

small tug to ensure that it is secured.

Fixing the trim and front

· Trims. The fabricated trims are held on by magnets, one each side at the top and one each side at the

bottom. The cast trims are held on by clipping over the hooks on the top front of the appliance and

screwing the fixing screws into the bottom of the trim.

Fronts. The screws on the back of the decorative front hook into the keyhole slots on the front of the

appliance below the glass screen. If necessary bend down the coal retaining plate on the front of the appliance.

Place more of the coal behind the cast front and arrange to partially obstruct the orange shell.