Diamond F200 T Manuel - Sayfa 4

Ticari Gıda Ekipmanları Diamond F200 T için çevrimiçi göz atın veya pdf Manuel indirin. Diamond F200 T 12 sayfaları.

CHAP 1 - CHARACTERISTICS OF THE INSTALLATION ENVIRONMENT

1.1 Preliminary directions

Installation must be carried out by following the instructions contained in this handbook and only by

specialized technical personnel. The manufacturer cannot be held liable for any damage caused

by a faulty installation.

Before starting the operations it is necessary to make sure the supply circuit is sized so as to

ensure correct operation in accordance with the power installed, and that an automatic

differential switch has been installed in proportion to the power drawn by the entire

system.

The position where the display cabinet has to be installed must have the following characteristics:

 The distance from the socket to be used must be such that, once connected, the power cable is

not stretched too much nor is an obstacle to free passage.

 The appliance is to be sufficiently aerated, far from heat sources, and not easily reacheable by

water.

 The air inlet slits for the compressor must not be obstructed.

After unpacking check the integrity of the various elements before going ahead with installation, in

the event of damage or defective components address to professionally qualified personnel.

Before carrying out the electrical connection make sure that the specifications of the rating plate

correspond to the values of the electric power supply mains. The rating plate is located on the

top of the display cabinet.

To ensure electrical safety it is necessary to make sure that the display cabinet is correctly

connected to an effective earthing system. For this purpose use the screw marked with the

symbol. In case of doubt ask for the assistance of qualified personnel.

If the socket to be used doesn't fit with the appliance's plug, have the socket replaced with a

suitable one by a specialized technician. If you need to use adapters, multiple sockets, and/or

extensions, you have to use only components in conformity with the current safety standards

(EN 60204) according to the electrical characteristics of the display cabinet.

CHAP 2 - FITTING

Page 3 of 11