Burley FLATBED Kullanım Kılavuzu - Sayfa 6

Hitching the Burley Flatbed to Your Bicycle

The trail er hitch was

designed to quick ly

and safe ly at tach to

vir tu al ly all types of

bi cy cles. It is in sert ed

in front of the left

rear drop out of your

bicycle.

Loos en the knob

on the eye bolt un til

the two arms are

spread fully apart.

Slip the low er hitch

arm un der the chainstay (A) and the up per arm above the seatstay (B). (See

il lus tra tion above.) Wedge the hitch cone all the way back into the an gle

formed by the stays at the wheel. Tight en the knob un til the arms are ﬁ rm ly

clamped against the stays. Wrap the safe ty strap around the in side of the

chainstay, over the hitch body, and back to the D-ring at the end of the

tongue.

Make sure that the cone is wedged se cure ly into the stays. The knob should

be ﬁ n ger-tight; do not over tight en. The hitch should not move, but should

al low the bi cy cle com plete move ment, in clud ing ly ing it down on the

ground. It should clear any racks, bags, or ﬁ t tings you have on your bi cy cle. If

there is any in ter fer ence, con tact your Burley dealer.

IMPORTANT: Re move trailer from your bi cy cle when it's not in use to

pre vent de form ing the plastic hitch.

Do not operate trailer without hitch safety strap prop er ly

installed. A dangling safety strap can contact spokes and

damage rear wheel or cause ac ci dent re sult ing in se ri ous

injury.

Burley Flatbed Owner's Instruction and Safety Manual