Burmester 035 Kullanıcı El Kitabı - Sayfa 10

Amplifikatör Burmester 035 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Burmester 035 16 sayfaları.

With the exception of the AC mains switch all operating controls are located on the front panel. To operate the unit it

must be connected to the AC supply.

AC mains switch

The AC mains switch (19) which turns AC power to the unit on and off is located on the

rear panel above the AC mains terminal. By switching to the ON position the transformer is

powered up.

POWER switch

The POWER switch (16) turns the unit on and off provided the AC mains switch is in the

ON position.

Whether the POWER switch is set to "OFF" all functions of the pre amplifier are

deactivated.

Turning the POWER switch from "OFF" to "STBY" position the STANDBY LED (4) will

illuminate due to the fact the pre amplifier stands in standby mode.

When the POWER switch is in "STBY" position the unit can be turned on and off by pushing

up the POWER switch or pushing the POWER button on the BURMESTER remote control

(accessory).

In operating mode (ON) the POWER LED (17) lights up and all functions of the pre amplifier

are activated.

PLEASE NOTE: Always switch off the 035 with the POWER switch first before bringing the

AC mains switch into OFF position.

VOLUME knob

The VOLUME knob (6) controls the volume level in 61 steps from 00 (off) to 60 (full

volume). The selected volume level will be shown in the alphanumeric display (5).

The responsivity of the VOLUME knob can be selected in the SETUP menu.

Input select

Inputs are selected by pressing the respective input select button PHONO (8), CD (9),

TUNER (10), AUX (11), TAPE (12). The alphanumeric display (5) indicates the selection.

SURROUND input

Pressing the button SURR (14) activates the INPUT SURROUND (26). The signal from the

SURROUND input is routed directly to the PREAMP outputs, bypassing tone control and

volume control.

MONITOR function

Pressing the button labeled MONITOR (15) blocks the direct signal path during recording

and switches to replaying the just recorded signal. When the monitor function is activated

an –M is added to the selected input in the alphanumeric display.

The inputs TAPE and SURROUND have no monitor function.

DISPLAY button

Pushing the button labeled DISPLAY (1) varies the brightness of the alphanumeric display

in four steps between "max. brightness" to "off".

If brightness is selected to "off", the display will light up only when any controls are used to

change settings. After a few seconds it automatically switches off again.

In SETUP mode display lights up on "max. brightness" permanently.

OPERATING CONTROLS