Diamond P07EN10038 Talimat, Kullanım ve Bakım Kılavuzu - Sayfa 8
Fırın Diamond P07EN10038 için çevrimiçi göz atın veya pdf Talimat, Kullanım ve Bakım Kılavuzu indirin. Diamond P07EN10038 12 sayfaları.
Sayfayı Yazdır
5 CONTROLS
Diagram of the control panel
6 METHOD OF USE
Functional check
Before switching the oven on check:
•
You have removed the protective film, if provided;
•
The plug is properly inserted into the power supply wall socket;
•
That the system supply voltage, frequency and power are compatible with the values provided on the label affixed
on the right side of the oven;
Switching on the oven for the first time
The first time the appliance is used it is recommended to heat the oven when empty to eliminate bad smells caused by the
evaporation of moisture content of the refractory stones, in the insulating material and the metallic parts inside.
Follow the procedure below:
•
fully open the exhauster valve;
•
turn the main switch in position "1";
•
leave the oven working (empty) for at least 8 hours at the temperature of 150° before proceeding to the first baking.
DURING THE " Switching on the oven for the first time" DO NOT TOUCH THE
m
PAINTED PARTS OF THE OVEN (FACADE and FRONT OF THE CONTROLS) IN
ORDER TO AVOID REMOVING THE PAINT THAT WILL CONSOLIDATE FINALLY
AFTER THIS FIRST PHASE.
1.
Main switch ;
2.
Cooking chamber light
switch ;
3.
Analogic thermometer;
4.
Top thermostat;
5.
Pilot light TOP;
6.
Bottom thermostat;
7.
Pilot light thermostat;
18