Aquasana AQ-7000 Kurulum Talimatları - Sayfa 2

Su Filtrasyon Sistemleri Aquasana AQ-7000 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Aquasana AQ-7000 2 sayfaları. In-line refrigerator & fountain filtration system
Ayrıca Aquasana AQ-7000 için: Kurulum Talimatları (2 sayfalar)

Sayfayı Yazdır

Filter Installation

Parts and Material Included

• Filter Cartridge

• Adjustable plastic strap

• Installation instructions

Install in a location that is

Install away from direct sunlight

not susceptible to freezing

as prolonged exposure to light

temperatures.

can weaken plastic components.

1. Turn off water supply to refrigerator

2. Locate an easily accessible section of refrigerator water supply tubing or supply line to

refrigerator from under-sink.

3. If installing on the back of a refrigerator; cut and remove a

11.5" section of refrigerator water supply tubing.

• U se a tube cutter for copper tubing and a utility knife for plastic

tubing. Make sure ends are square.

4. Referring to "Using Push-In Fittings" section below, insert refrigerator water supply tubing into

inlet push-in fitting on filter.

5. Turn on the incoming water supply and flush the filter into a

bucket. Run water for 2-3 minutes. The initial surge of water may be

discolored due to carbon fines.

6. Shut off water supply again. Referring to "Using Push-In Fittings"

section, insert water supply tube from refrigerator into outlet fitting.

7. Use plastic strap to secure filter to back of refrigerator or under sink.

8. Turn on water supply to refrigerator and check for leaks.

Using Push-In Fittings

To Attach Tubing

Push tubing in as far as it will go. tubing must

be inserted past o-ring and hit backstop. Pull

tube to ensure it is secured.

baCkstoP

tools & Parts Needed

• Tube Cutter or Utility Knife

• Bucket for flushing filter

a water supply line must be run

to the refrigerator or fountain

prior to installation of this filter.

Correct

Incorrect

FLOW

To Release Tubing

Push in grey collet to release tubing.

With collet held, pull tubing straight out.

Collet

Filter Replacement

1. Turn off water supply to refrigerator.

2. Referring to section "Using Push-In Fitting", release tubing from both ends of filter.

3. Referring to "Using Push-In Fittings" section, insert refrigerator water supply tubing into inlet

push-in fitting on filter.

4. Turn on the incoming water supply and flush the filter into a bucket. Run water for 2-3 minutes

to flush out air.

5. Shut off water supply again. Referring to "Using Push-In Fittings" section, insert water supply

tube from refrigerator into outlet fitting.

6. Turn on water supply to refrigerator and check for leaks.

Troubleshooting

If water leaks at Push-in Connections: Push tubing in as far as it will go. If leaking continues, shut

off water at the original valve and remove water line by pushing in on the connector collar while

pulling the tubing away. See, "Using Push-In Fittings" section. Inspect tubing for cracks and

scratches. If tubing is cracked or scratched, simply cut that portion away and reinsert new end of

tubing into fitting. Make sure tubing is cut straight. If not, re-cut.

Do not use with water that is microbiologically unsafe or of unknown

quality without adequate disinfection before or after the system.