Aquasana EQ-OPTM-X Kullanıcı El Kitabı - Sayfa 3

Su Filtrasyon Sistemleri Aquasana EQ-OPTM-X için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Aquasana EQ-OPTM-X 10 sayfaları. Whole house water filter

Sayfayı Yazdır

SYSTEM CONFIGURATION

If you have added components to your OptimH2O

note the correct sequencing below.

Filter Cap

Filter Housing

Incoming

Water Supply

Shut-off

Valve

Pre-Filter

Before installing

• Lay out system in appropriate configuration. Improper sequence

of equipment will affect performance, and could possibly damage

your system.

• For all installations: Anticipate the need for additional parts and pieces

including but not limited to PEX tubing, clamps, and mounting screws to

install unit properly (available at a local home improvement stores or through

your plumbing contractor). Due to the varieties of home design, not all

configurations can be addressed in this guide.

• DO NOT install this filter where the line pressure may exceed 100 psi.

The operating pressure range for this filter is between 20psi – 100psi.

• Install on cold water lines only (40° – 90°F).

• Installation of the filtration system must comply with existing state and

local plumbing codes. Aquasana and its manufacturer are not liable for

consequential or incidental damages due to improper installation.

• DO NOT install the unit on its side. It must be installed upright

to maximize contact with media bed.

Water Filter System,

Salt Free Conditioner

Optional

UV Filter

Optional

Read all precautions and installation instructions

carefully and completely before installing.

Precautions

• Properly tighten all fittings to

ensure a leak-free assembly.

• NSF certified Plumber's Tape is

the only sealer that can be used

on threaded fittings. DO NOT use

pipe dope or PVC primer/glue on

threaded fittings. Exposure to these

compounds will damage nipples

causing leaks.

• Pick an appropriate installation

location. Dimensions of systems

vary—always allow an estimated

minimum of 60" clearance for

height of tank, and a minimum

of 45" for floor space.

• Unit must be installed in an area

where the main water line enters

your home, before connecting to

the water heater. DO NOT install

after a water heater or on the

hot water line.

• It is recommended your system

be installed indoors and out of

direct sunlight. Prolonged

exposure to light can weaken

plastic components, resulting in

filter housing failure. If this is not

possible and the system is outdoors

or in a sunny area, the unit must be

protected from both direct sunlight

and freezing temperatures.

• If installing on metallic plumbing,

two grounding clamps and #4

copper wire are essential for safety.

• Some local codes may require the

use of a licensed plumber or certified

installer when disrupting

a potable water line.

• In areas with high pressure, a

pressure relief valve and a water

hammer arrestor may be necessary.

USE & CARE

Cleaning

The exterior of your filtration

system can be cleaned with warm,

soapy water. Rinse well with fresh,

clean water.

NOTE: Never use chemical cleaning

products on the system's exterior surface

as they may damage the housing.

Specifications

This filter system is designed and

tested for use with genuine Aquasana

parts including replacement filters and

all hardware. Use of parts from other

manufacturers may result in loss of

contaminant reduction performance,

system damage or failure. Use of parts

from other manufacturers will also

void your warranty. Please visit

aquasana.com for replacement parts.

A Pre-Filter is included with your

system. Sediment levels vary from one

location to another. It is recommended

to replace your Pre-Filter every 6

months. If the flow rate has noticeably

decreased, replace your filter cartridge

sooner.

Model: EQ-OPTM-X

Replacement tank: EQ-OPTM-R

Additional Replacements:

20" Pre-Filter: EQ-OPTM-PRE-R