Diamond 350/VCS-N Kullanım ve Bakım Kılavuzu - Sayfa 14
Mutfak Aletleri Diamond 350/VCS-N için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Diamond 350/VCS-N 16 sayfaları.
Sayfayı Yazdır
having taken off the trolley, the goods
-
holder plate can be carefully cleaned
with warm water, the equipped deter-
gent or neutral detergent (pH 7).
6.2.2 - Cleaning the blade, the bladeguard and the ring
WARNING: a pair of metallic gloves
must be worn while cleaning the bla-
de (1) (Fig. n°49) and a damp cloth
must be used.
Unscrew the hand grip from the blade-
guard tie rod (3) and extract the blade-
guard (2) using the proper grip to hold it
(Fig. n°49). At thid point it is possible to
clean the blade (Fig. n°50).
To clean the surfaces opposite the
blade and the ring, the blade must be
extracted in the following way:
1.unhook the bladeguard (Fig. n°49);
2.take out the sharpening device (Fig.
n°51 ref.a) and open, by using the
graduated hand grip, the thickness
gauge enough to make the jig (Fig. n°
51 rif.b) stick to the blade;
3.unscrew the three or four screws (Fig.
n°51 ref.f), depending on the model,
which fasten the blade;
4.rest the jig (b) on the blade, so that
the split in the jig fits in the ring (Fig.
n°51 ref.c);
5.match the axes of the two holes (Fig.
n°51 ref.d) on the blade with the two-
knobs (Fig. n°51 rif.e) on the jig,
simply making the blade turn to the
desired position;
6.screw the two knobs (e) without
excessively tightening them.
N.B. The bladeguard must be clea-
ned with warm water, the equipped
detergente or with neutral detergent
(pH 7).
pH
7
Fig. n°48
1
3
2
Fig. n°49
Fig. n°50
a
b
d
e
f
Fig. n°51
24
6.2.3 - Cleaning the sliceguard
(Fig. n°52)
To remove the sliceguard simply grasp
the hand grip (1) and pull up so that the
two pins unhook (2), and then extract
the sliceguard.
At this point clean the sliceguard with
warm water, the equipped detergent or
with neutral detergent (pH 7).
6.2.4 - Cleaning the sharpener
To clean the sharpener it is necessary
to adhere to the following instructions:
1. lift (a) the cap up to the top;
2. loosen the knob (1);
3. lift (b) the cup (2) and extract it so
that the knob (1) passes through the
larger opening in the cup (2);
4. rub the grinders with a brush, while
cleaning the other components with
warm water, the equipped detergent
or with neutral detergent (pH 7).
c
6.3 - SLIDE GUIDES LUBRICATION
The slide guides on the carriage (1-2)
must be lubricated periodically with the
equipped oil (a).
2
1
1
Fig. n°52
a
Fig. n°53
b
1
2
Fig. n°54
a
Fig. n°55
1
25
2
2