AquaScape 45009 Talimatlar ve Bakım - Sayfa 5

Su Pompası AquaScape 45009 için çevrimiçi göz atın veya pdf Talimatlar ve Bakım indirin. AquaScape 45009 20 sayfaları. Adjustable flow pond pump
Ayrıca AquaScape 45009 için: Talimatlar ve Bakım (20 sayfalar)

Sayfayı Yazdır

• The AquaSurge includes a wide assortment of fittings from

which to choose. Select the appropriate fitting or fittings

needed for your application.

NOTE: If using a check valve, please follow the installation

instructions included with the check valve for proper

plumbing steps.

• The threaded collar, on all of the fittings enables the

AquaSurge pump to be installed and removed without the

need for any tools (Ex. 3).

NOTE: Do not use tools to install the fittings to the pump

discharge. Fittings need to be only hand-tight.

• The extremely versatile rotational ball outlet provides you

the ability to adjust the pump discharge to the perfect

position your water feature set up requires. Loosen the

threaded collar on the rotational ball and rotate to desired

position (Ex. 4). A flat rubber gasket is included to ensure

a hand-tight and leak-free connection. Make sure this flat

rubber washer is in place before installing the fittings

(Ex. 5).

Ex. 4

• Install the right sized multi-hose adapter based on the

diameter of the tubing you are using.

• If using a pipe diameter larger than the smallest section

of the multi-hose adapter, trim off the smaller sections to

avoid flow restriction (Ex. 6).

☎

aquascapeinc.com |

CAN (866) 766-3426 |

Hosetail ready for 1" tubing

Hosetail ready for 1½" tubing

• In some instances the tubing may be tight or difficult to

connect to the fitting. If this is the case, we recommend

heating the hose with a hair dryer or dipping the hose for

a few seconds in very hot water. Lubrication can also be

used; we recommend silicone grease or olive oil. Put the

fitting on the pump before attaching the tubing/hose. Once

Ex. 3

the fitting is in place, attach the tubing/hose onto the fitting

with a twisting motion.

• Lower the pump into the skimmer or Pondless filter

(Ex. 7) and rotate the rotational ball output to line up with

the tubing. Attach tubing to the fitting and then tighten a

hose clamp (not included) to secure tubing onto the fitting.

In-Line Operation

• The AquaSurge pump can also be operated "in-line" by

attaching a pipe connected directly from the pond (or

aquarium) pump inlet. In this case the water must be

Ex. 5

pre-filtered of debris to prevent damage to the pump. The

pump must NEVER be operated dry without water. This

pump is water-cooled and requires water flowing through

the pump at all times to operate correctly and stay cooled.

☎

US (866) 877-6637

Hosetail ready for 1¼" tubing

CUT

HERE

Installation of stainless

steel hose clamp

stainless steel

CUT

hose clamp

HERE

KINK-FREE

TUBING

Ex. 6

Ex. 7