Diamond ICE115AS-R2 Manuel - Sayfa 9

Buz Yapıcı Diamond ICE115AS-R2 için çevrimiçi göz atın veya pdf Manuel indirin. Diamond ICE115AS-R2 19 sayfaları.

Should you decide to scrap appliance, first disconnect the power

cable from the mains, and then cut the cable off.

In addition, proceed as follows:

• break off and remove the door in order to prevent the possible

danger of a child getting trapped inside

• do not allow the coolant gas and oil in the compressor to disperse

into the environment

• dispose of or recover the various materials according to the

provisions established by the current laws in force in your Country

IMPORTANT: this appliance contains flammable gas which

could cause a hazard during transport and/or final treatment.

This symbol means that this product should not be treated as a household waste. To prevent potential negative

consequences for the environment and health, be sure this product is correctly disposed of and recycled.

For information on the disposal and recycling of this product, contact your Distributor or the Waste Treatment Service.

This appliance does not contain coolant that damages the ozone layer. This appliance contains fluorinated greenhouse

gases covered by the Kyoto Protocol. This product is hermetically sealed.

The Manufacturer shall not be liable for any damage to the environment, animals, persons or objects caused by

incorrect installation.

2 TECHNICAL DATA (Fig. 1)

The voltage and frequency are given on the data plate on the appliance. Refer to this data plate to check compliance.

Voltage (1), power (2), model (3), serial No. (4), Manufacturer (5).

The weighted equivalent continuous sound level A of this appliance is less than 70 dB(A). The measurements were taken 1 metre

from the surface of the appliance and 1.60 metres above ground, during ice production.

The wiring diagram is stuck on the front counterpanel or inside front panel of the appliance.

In order to gain access thereto, unplug the appliance from the power source, loosen the screws holding the front panel, and slide it

away after first opening the door.

3 ADVICE ABOUT TRANSPORTATION

The net weight and the weight including packaging of the appliance are given on the cover of this instruction manual. Please refer

to the instructions on the packaging in order to correctly transport and lift the appliance.

To prevent the oil in the compressor from flowing back into the coolant circuit, always make sure that the appliance is kept upright

during transport, storage, and handling. Follow the instructions given on the packaging.

The appliance must be installed by authorized personnel, in compliance with the current laws in force and the

Manufacturer's instructions.

Once you have removed the packaging according to the instructions on the box, MAKE SURE THAT THE APPLIANCE IS IN A

PERFECTLY GOOD CONDITION. IF IN DOUBT, DO NOT USE IT AND IMMEDIATELY CONTACT THE DEALER who sold it to

you.

All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must be removed and put out of the reach

of children, as they are potential sources of danger.

Rest the wooden pallet on the floor and, using a hex socket wrench, loosen and remove the bolts (Fig. 2) that fix the appliance to

the pallet.