Diamond ICE20A Kurulum, Kullanım ve Bakım Kılavuzu - Sayfa 9

Buz Yapıcı Diamond ICE20A için çevrimiçi göz atın veya pdf Kurulum, Kullanım ve Bakım Kılavuzu indirin. Diamond ICE20A 15 sayfaları. Automatic ice - cube maker

Sayfayı Yazdır

Should you decide to scrap appliance, first

disconnect the power supply cable from the mains,

and then cut the cable off.

In addition, proceed as follows:

•

Break off and remove the door in order to

prevent the possible danger of a child getting

trapped inside.

•

Do not allow the coolant gas and oil in the

compressor to disperse into the environment.

•

Dispose of or recover the various materials

according to the provisions established by the

current laws in force in your country.

This appliance does not contain coolant that

damages the ozone layer.

The manufacturer shall not be liable for

any damage to the environment, animals,

persons or objects caused by incorrect

installation.

2 TECHNICAL DATA (Fig. 1)

The voltage and frequency are given on the data

plate on the appliance. Refer to this data plate to

check compliance.

Voltage (1), power (2), model (3), Serial No. (4)

manufacturer (5).

The weighted equivalent continuous sound level A

of this appliance is less than 70 dB (A). The

measurements were made over an entire

production cycle, at a distance of 1 m from the

surface of the appliance and at a height of 1.60 m

from the floor.

The wiring diagram is stuck on the front counterpanel

of the appliance.

In order to gain access thereto, unplug the appliance

from the power source, unscrew the screws holding

the front panel, and slide it away after first opening.

3 ADVICE ABOUT TRANSPORTATION

The net weight and the weight including packaging

of the appilance are given on the cover of this

Instruction Manual. Please refer to the instructions

on the packaging in order to correctly transport and

lift the appliance.

To prevent the oil in the compressor from flowing

back into the coolant circuit, always make sure that

the appliance is kept upright during transport,

storage, and handling. Follow the instructions given

on the packaging.

4 UNPACKING

The appliance must be installed by authorized

personnel in compliance with the current laws

in force and the manufacturer's instructions.

Once you have removed the packaging according

to the instructions on the box, make sure that THE

APPLIANCE IS IN A PERFECTLY GOOD

CONDITION. If in doubt, DO NOT USE IT and

immediately CONTACT the dealer who sold it to you.

All the packaging items (plastic bags, cardboard,

polystyrene foam, nails, etc.) must be removed and

put out of the reach of children, as they are potential

sources of danger.

Rest the wooden pallet on the floor and, using a

hex socket wrench, loosen and remove the bolts (6

Fig. 2) that fix the appliance to the pallet.

Lift the appliance using equipment fit to bear its

weight. Separate the appliance from the wooden

pallet and fit the supplied feet into the housings on

the base plate provided for the purpose. (7 Fig. 3).

Use a spirit level to ensure that the appliance is

standing perfectly level. If necessary, adjust the feet.

5 INSTALLATION

5.1 CONNECTION DIAGRAM (see Fig. 4)

8. Plug

9. Socket with switch

10. Water tap

11. Water supply pipe

12. Water drainage pipe