Diamond 60/60 PCE Series Hızlı Başlangıç Kılavuzu - Sayfa 5

Menziller Diamond 60/60 PCE Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Diamond 60/60 PCE Series 13 sayfaları. Range, gas solid top
Ayrıca Diamond 60/60 PCE Series için: Kurulum - Kullanım - Bakım (19 sayfalar)

Sayfayı Yazdır
2

PREPARING FOR INSTALLATION

The appliance must be positioned in a well aerated place, if possible under a suction hood
to ensure complete evacuation of the steam created when cooking. Before using the
appliance for the first time, remove all the protection sheets, clean all the surfaces with a
soft cloth, warm water and soap to remove all traces of the antirust products applied during
production.
To install the appliance close to walls, partitions, kitchen units, decorative claddings, etc.,
they ought to be made with non flammable materials or leave a gap of at least 100 mm
between them and the appliance.
It is essential to comply with the fire prevention rules.
The appliances can be positioned, depending on the model, as top appliances. floor-
standing appliances or in series together with others in our range on bases or stands.
The main switch and outlet must be near the appliance and easy to reach.
Level the appliance, adjust its height and stability by turning the levelling feet.
2.1
LAWS, TECHNICAL REGULATIONS AND GENERAL RULES
Comply with the following rules during installation:
1) accident prevention standards;
2) the laws in force in the country where the appliance is installed;
3) read all the indications given in this handbook carefully as they provide important
information for safe installation, use and maintenance;
4) keep this handbook in a safe place for future reference by those who use the
appliance.
2.2
INSTALLATION
Only specialised personnel should install, start and service the appliance.
Installation must be carried out in compliance with the laws in force in the country where
the appliance is installed.
The manufacturer declines all responsibility if the appliance malfunctions due to incorrect
installation, tampering, improper use, bad maintenance, failure to comply with the local
laws and inexperience in using the appliance.
INSTRUCTIONS FOR THE QUALIFIED INSTALLER
APPLIANCE WEIGHING MORE THAN 40 Kg
CONNECT THE POWER CABLE
TO THE TERMINAL BOARD BEFORE PUTTING
THE APPLIANCE IN ITS FINAL POSITION