Panasonic WV-SC384 Kurulum Kılavuzu - Sayfa 14
Video Kamera Panasonic WV-SC384 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Panasonic WV-SC384 40 sayfaları. Ip video cameras
Ayrıca Panasonic WV-SC384 için: Teknik Özellikler (2 sayfalar), Kurulum Kılavuzu (40 sayfalar), Kurulum Kılavuzu (40 sayfalar), Entegrasyon Notu (8 sayfalar)
Sayfayı Yazdır
Rear view
12 V DC power supply terminal
About the [INITIAL SET] button
After turning off the power of the camera, turn on the power of the camera while holding down this button, and wait for
around 5 seconds or more without releasing this button. Wait around 3 minute after releasing the button. The camera will
start up and the settings including the network settings will be initialized. Before initializing the settings, it is recommended
to write down the settings in advance. The initialization will be complete when the live indicator stops blinking orange and
lights off. Note that the preset position settings and the CRT key (SSL encryption key) used for the HTTPS protocol will not
be initialized.
Important:
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may fail to initialize and may
cause malfunction.
Bottom view
Important:
• Do not use this hole to mount on the ceiling since the fall prevention measure is unavailable.
14
Access indicator
(blinking at accessing)
10BASE-T/
Link indicator
100BASE-TX
LINK
(lighting at linking)
Network connector
INITIAL SET button
Cable guide
Audio output connector
ACT
INITIAL
POWER
EXT I/O
MIC/LINE IN
AUDIO OUT
MONITOR OUT
SET
12V IN
4 3 2 1
Screw hole for a tripod
(1/4-20 UNC for tripod)
Monitor out connector
for adjustment
Safety wire holder
Microphone/line input connector
External I/O terminals