Diamond Antenna K400 Manuel - Sayfa 2
Anten Diamond Antenna K400 için çevrimiçi göz atın veya pdf Manuel indirin. Diamond Antenna K400 2 sayfaları.
Sayfayı Yazdır
Tilt angle adjustment of the
K400 bracket
2) Remove antenna mounting section
of the bracket, and rotate it as shown
in the gure. Loosen bottom screw
with large hexagonal wrench.
1) Remove socket bolt with large
hexagonal wrench.
loosen bottom
antenna mounting
screw
section
3) Rebuild antenna mounting section
as shown in the gure, and adjust
tilt angle to make the antenna vertical.
DIAMOND ANTENNA Products are distributed by RF PARTS COMPANY
435 S. Paci c S treet
www.diamondantenna.net
K400
K400C
coax & PL259
K400CNMO
coax & PL259
K400-3/8C
coax & PL259
K400 series mounts may be grounded by trimming
1/2" from the aluminum reinforcement strip supplied
with mount. Outside two set screws to ground.
San Marcos, CA
920 78
(770) 614-7443
K400 Parts List
Trunk lid, hatchback mount bracket
Protection plate
Rubber protection cap
Set screws (short)
Hexagonal wrench (small)
Hexagonal wrench (large)
Mount Only
UHF base w/6.5 ft. RG316 te on
NMO base w/6.5 ft. RG316 te on
3/8 24 base w/6.5 ft. RG316 te on
K400 Grounding
K400 Series Mounts