Panasonic WV-SW395 Kurulum Kılavuzu - Sayfa 33

Video Kamera Panasonic WV-SW395 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Panasonic WV-SW395 40 sayfaları. Ip video cameras
Ayrıca Panasonic WV-SW395 için: Teknik Özellikler (2 sayfalar), Broşür (2 sayfalar), Karşılaştırma Tablosu (6 sayfalar), Kurulum Kılavuzu (40 sayfalar), Kurulum Kılavuzu (40 sayfalar), Entegrasyon Notu (8 sayfalar)

Sayfayı Yazdır

Symptom

Live indicator keeps on

blinking orange approx. in 2

seconds intervals.

Live indicator never lights up.

Live indicator keeps on

blinking red.

Live indicator lights red.

Audio input contains noise.

• UPnP

error has occurred since the power is not supplied to the

router.

Turn on the power of the router. Wait until the connections are

established.

• An error has occurred during the port update by the UPnP func-

tion.

If the router in use does not support the UPnP function, perform

the port forwarding setting for the router. In addition, deactivate the

setting of auto port forwarding for the camera.

• UPnP function of the router is disabled.

Refer to the operating instructions of the router to enable the

UPnP function.

• Is "Off" selected for "Indicator" on the "Basic" page?

Select "On" or "On(Access)" for the indicator setting.

• The camera may be out of order.

Contact your dealer.

• Refer to our website

(http://security.panasonic.com/pss/security/support/info.html) for

further information after checking the displayed contents of the

"Maintenance" page - the [Status] tab - "Self check" of the setup

menu.

• Isn't the write protect switch of the inserted SDHC/SD memory

card set to "LOCK"?

Unlock the write protect switch of the SDHC/SD memory card.

• Hasn't the inserted SDHC/SD memory card been formatted on a

PC?

Use an SDHC/SD memory card formatted on the camera.

Or install the software to format the SDHC/SD memory card on

the PC. Refer to our website

(http://security.panasonic.com/pss/security/support/info.html) for

further information about the supported software.

• Isn't the inserted SDHC/SD memory card faulty?

Replace the card with a normal one.

• Check the following.

• Grounding of the camera, a switching hub or peripheral devices

are not done.

• The camera is used near an electrical power line.

• The camera is used near a device which produces strong mag-

netic field or radio waves (such as near a TV/radio antenna, a

motor of an air conditioning system, a transformer, etc.)

When audio input still contains noise even after checking the

above possibilities, use a powered microphone or connect audio

output with low output impedance.

Cause/solution

Reference

pages

−

Operating

Instructions

(included in

the CD-ROM)

−

Operating

Instructions

(included in

the CD-ROM)

−

Operating

Instructions

(included in

the CD-ROM)