Panasonic CT-27D20 Kullanım Talimatları Kılavuzu - Sayfa 6

TV Panasonic CT-27D20 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic CT-27D20 44 sayfaları. 36" diagonal stereo monitor-receiver
Ayrıca Panasonic CT-27D20 için: Kullanım Kılavuzu (44 sayfalar), Kullanım Talimatları Kılavuzu (21 sayfalar)

Sayfayı Yazdır
Installation
installation
Television Location
This unit is intended to be used with an optional stand or entertainment center.
Consult your dealer tor available options.
□
Avoid excessive sunlight or bright lights, including reflections.
□
Keep away from excessive heat or moisture. Inadequate ventilation may cause internal
component failure.
□
Fluorescent lighting may reduce remote control transmitting range.
□
Keep away from magnetic equipment, including motors, fans and external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between components. For best
results:
□
Use 75-ohm coaxial shielded cables.
□
Use appropriate input and output connectors, that match your component connectors.
□
Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION:
TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE A PLUG WITH A
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE. FOR SOME MODELS THAT ARE
NON-POLARIZED, THE USE OF AN AC ADAPTOR CONNECTOR MAY
BE NECESSARY.
Polarized plug
Non-Polarized plug
Cable / Antenna Connection
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local cable company.
Note:
A cable converter box may be required for proper reception. Check with
your local cable company for compatibility requirements.
□
Antenna Connections
□
For proper reception of VHF/UHF channels, an external antenna is
required. For best reception an outdoor antenna is recommended.
□
Antenna Mode must be set to TV.
V ' V
Cable Preset
Cable Mode is preset at the factory. Antenna
users must change to Antenna Mode in the
Setup Menu.
Incoming Cable from
Cable Company
d*
75 Ohm VHF/UHF
on back of TV
Incoming Cable from
Home Antenna