Panasonic CT-31SF14 Kullanım Talimatları Kılavuzu - Sayfa 5

TV Panasonic CT-31SF14 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic CT-31SF14 36 sayfaları.

Sayfayı Yazdır

Installation

Television Location

This Television is intended to be used with an optional stand or entertainment center. Consult your dealer for available

options.

Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the

screen.

Use of some types of fluorescent lighting may reduce remote control transmitter range.

Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or

moisture.

To insure optimum color purity do not position equipment containing magents (motors, fans, external speakers, etc.)

nearby.

Optional External Equipment Connections

The Video/Audio connections between components can be made with shielded video and audio cables. For best

performance, video cables should be of 75 ohm type coaxial shielded cables. Cables are available from your dealer or

electronic supply house.

Before you purchase any cables, be sure you know what type of output and input connectors your various components

require. Also determine the length of cable you'll need.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE

SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED) PLUG

WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY

INSERTED TO PREVENT BLADE EXPOSURE.

Remote Control Battery Installation

Polarized Plug

Batteries: Use two "AA" batteries.

Remove the battery compartment cover on back of

the remote.

2. Install the batteries in the battery compartment.

(Polarity (+) or (-) must be correct.)

Reattach the battery cover.

Helpful Hints:

For frequent Remote Control users, replace old batteries with

Alkaline batteries for longer life.

Precaution on Battery Use

Incorrect installation can cause battery leakage and

corrosion that will damage the Remote Control.

Observe the Following Precautions:

1. Batteries must be replaced as a pair.

Do not combine a used battery with a new one.

3. Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").

Do not attempt to charge, short-circuit, disassemble, heat or burn used

batteries.

5. Battery replacement is necessary when Remote Control reacts

sporadically or stops operating the Receiver.

Helpful Hints:

Whenever you remove the batteries to replace

them, you may need to reset the Remote Control

Infrared Codes. We recommend that you initially

record the codes in the Infrared Remote Codes for

Specific Components section, prior to setting up the

remote._