Diamond Audio DES400.2D Kullanıcı El Kitabı - Sayfa 11

Amplifikatör Diamond Audio DES400.2D için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Diamond Audio DES400.2D 20 sayfaları.

SYSTEM SETUP

4.TURN-ON MODE OPTIONS - Conﬁgure the "Turn-On Mode" switch for desired turn-on trigger. There are 3 modes available

on the DES series ampliﬁer, REM, DC and VOX. 1 - (REM) is the standard 12V trigger wire, 2 - (DC) or DC offset, when

connected high level in, will sense differences in ground in your wiring through the speaker leads and turn on ampliﬁer,

3 - VOX (signalsensing) will sense signal input into the ampliﬁer RCA INPUT turning on the ampliﬁer. DIAMOND AUDIO

Bluetooth Controller. The most preferred and reliable method is using the REM setting with a 12V trigger wire connected

to the vehicles ignition and will provide instant on and off for the ampliﬁer. VOX and DC will provide turn on capabilities

for the ampliﬁer when a 12V trigger wire is not available. These methods will have some delay in turning the ampliﬁer

on and off.

"SWITCHED"

12 VOLTS

DC "OFFSET"

5. REMOTE LEVEL/REMOTE LEVEL "SLAVE" – These RJ11 ports are speciﬁcally designed to be used with the DIAMOND

AUDIO BASS REMOTE controller. This will allow direct plug in control (level)of the subwoofer output. It is a proprietary

design and can ONLY be used with Diamond Audio ampliﬁers. This controller allows the user to adjust the subwoofer

level control totally seperate from the bass EQ that is in your car audio source unit. It is a GAIN control that speciﬁcally

controls the subwoofers level from 0 to +12dB more GAIN. Be careful as this will cause distortion at high levels as no

car audio ampliﬁer has 12 dB of gain (this is equivalent to 20 times more power output DEMAND when the Remote

Bass knob is turned all the way up - clockwise) Assuming you have a 1,000 watt monoblock (like a DES1000.1D) you

would be asking the amplifer to produce 20,000 watts for a brief period of time. Also with our DES500.1D and

DES1000.1D there is an additional RJ11 Remote Bass Slave Port (See below). This makes using 2 DES monoblock

ampliﬁers subwoofer level adjustment simple using only ONE (1) Remote Bass Control. See below:

PASS THRU from

"MASTER" AMP

Remote Bass

Control

INPUT from

HeadUnit (sub out)

DES500.1D/DES1000.1D

To Sub

6 pin RJ11 cord

DES500.1D/DES1000.1D

To Sub

"VOX" VOICE

ACTIVATED

(signal sensing)

"SLAVE"

"MASTER"