Diamond Audio Technology D6 5.2 Kullanıcı El Kitabı - Sayfa 10

Araba Amplifikatörü Diamond Audio Technology D6 5.2 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Diamond Audio Technology D6 5.2 12 sayfaları. D6 series reference amplifiers

Sayfayı Yazdır

D6 5.2

Bridging

Only the pair of sub channels are capable of bridging on the D6 5.2 Amplifier. All other

channels are designed for single channel use only. Bridging the sub channels is

accomplished by using the left channel positive (+) output connection of the amplifier for

the speaker positive and the right channel negative (-) output connection of the amplifier

for the speaker negative.

Note: It is important that a 4 Ohm minimum total speaker impedance load is observed

on all D6 5.2 front, rear, and center channels and when bridging the sub channels on

the amp! If an impedance load of less than 4 Ohms is used, you will eventually

damage your amplifier and void your warranty.

RCA

CH 1/2 & 3/4 INPUTS

The RCA cables from your source unit or 5.1 processor should be inserted here.

SUB & CENTER CHANNEL INPUTS

The sub channel input is designed for input from your source unit if it is equipped with a

sub output. Otherwise, both the sub and center inputs must come from a 5.1 processors

output.

D6 5.2

Crossovers

The Diamond D6 5.2 amplifier features second-order 12dB/octave Butterworth filters.

These filter networks sum to a flat response at their -3dB break points. This results in a

smooth and seamless transition from one frequency band to the next. Butterworth filters

provide maximally flat frequency responses when compared to other filter structures.

All crossover controls are mounted on the signal input side of the amplifier. The D6 5.2

front and rear high pass crossovers are fixed at 80 Hz while the center highpass is fixed

at 120 Hz. Each of these crossovers has an individual network that can be defeated by

simple switch selection. When switched off, they are completely out of the audio path.

The sub channel crossover features fully selectable and adjustable sub-sonic, 17 - 80

Hz, and lowpass, 60 - 250 Hz, filters. The sub channel crossover also features a 180

degree phase invert and gain bypass.

Gain

This control matches the output voltage of the source unit or processor to the amplifier

inputs. Rotating this control to the "MIN" mark (counterclockwise) configures your D6

amplifier to accept input voltages as high as 5V RMS. This control should be set as low

as possible. The basic procedure for setting input gains is as follows:

1. Adjust all amplifier gain controls to just above the minimum setting (fully

counterclockwise).

2. Using the highest quality source (usually CD) play some music and slowly turn up the

source unit until you can hear distortion. Now turn down the volume until the distortion

stops. This is your maximum source unit level.

3. Turn up the amplifier gain until audible distortion starts. Turn down the gain to the

point JUST BELOW the start of the distortion.

4. Repeat step 3 for all channels on your D5 5.2.

Gain Bypass Select

Pushing this button "IN" bypasses the gain stage on the sub channels only. This is used

in systems with a pre-amp section before the sub channels or to slave those channels to

a master amplifier. Leaving this button "OUT" is the default and uses those channels

gain as a normal input level match.