AquaSure FORTITUDE PRO Series Manuel - Sayfa 11

Su Sistemi AquaSure FORTITUDE PRO Series için çevrimiçi göz atın veya pdf Manuel indirin. AquaSure FORTITUDE PRO Series 20 sayfaları. Whole house water treatment system
Ayrıca AquaSure FORTITUDE PRO Series için: Kullanıcı El Kitabı (12 sayfalar)

Sayfayı Yazdır

STEP 3.

Mounting the Pre-Filter

1. Position the system on the wall at the desired mounting

location with minimum of six (6) inches of ground clearance

from the floor to the base of the system.

2. Using a pen or pencil and mark the mounting hole on the

back of the bracket onto the wall.

Note: Please make sure the bracket mount is leveled using

a leveling tool to ensure evenly distributed stress on the

bracket. Make sure the mounting point is position on a stud

to properly secure the bracket.

3. Mount the system onto the wall using the provided Lag Bolts

and Washers.

STEP 4.

Attaching the Water Supply Pipe to the Pre-Filter

1. Wrap the 1" male threaded fittings that will be used to connect the

plumbing to the pre-filter with five (5) to six (6) wraps of Teflon tape.

2. Attach the 1" male threaded fitting from the incoming water supply

plumbing to the IN port and OUT port of the pre-filter system.

Note: Use the 1" to 3/4" inch male adapter for 3/4" plumbing

STEP 5.

Installing the Pre-Filter Cartridge

1. Unwrapp the filter cartridge and place it inside the

housing. Make sure the filter is centered on the stand

pipe located inside the housing at the base.

2. Screw on the housing with the filter inside and

screw onto the corresponding head by turning it

counterclockwise using the supplied housing wrench.

Note: Make sure the o-ring is inside the housing

and do not over tightening the housing.

AQUASURE

FORTITUDE PRO SERIES