3Built RES126VX Hızlı Başlangıç Kılavuzu - Sayfa 4
Uzaktan Kumanda 3Built RES126VX için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. 3Built RES126VX 9 sayfaları. Remote engine shut-off
Ayrıca 3Built RES126VX için: Kurulum Talimatları (5 sayfalar), Kurulum Talimatları (3 sayfalar)
Sayfayı Yazdır
RESET RECEIVER
All programming must happen within 10 seconds of powering the receiver.
1) The Receiver's memory can be entirely erased of all transmitter codes.
2) Disconnect power to the Receiver for a few seconds and reconnect.
3) Push the bottom button on the transmitter for 7 seconds and release.
4) You will hear 5 short beeps from the Receiver indicating that all codes have been
erased.
5) Disconnect power to the Receiver for a few seconds.
6) When the receiver is powered again it will emit a continuous beep indicating that it is
ready to receive a new transmitter LOCK code. It will not function until a transmitter has
been programmed.
7) Press and release the LOCK button.
8) The receiver will beep once.
9) Press and release the UNLOCK button.
10) The receiver will beep twice.
11) Disconnect power to the Receiver for a few seconds.
12) Connect power to the Receiver and test new Transmitter by pushing the Lock and then
the Unlock buttons.
©2020 3Built LLC
STANDARD TRANSMITTER
Page 4 of 9
10/5/2020