3Built RES12VLAB Kurulum Talimatları Kılavuzu - Sayfa 3

Uzaktan Kumanda 3Built RES12VLAB için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. 3Built RES12VLAB 9 sayfaları. Remote engine shut-off

Sayfayı Yazdır

ii) Yellow – System is in Left/Yellow lane mode. Receiver will respond to Team Transmitter and Yellow button on Master

Transmitter.

iii) Red – System is in Right/Red lane mode. Receiver will respond to Team Transmitter and Red button on Master

Transmitter.

iv) Solid light indicates Receiver is in RUN mode.

v) Blinking light indicates Receiver is in OFF mode.

vi) The Receiver consumes a small amount of power from the battery. (This is normal for all radio frequency receivers.)

We recommend shutting the Receiver off with the toggle switch when not in use.

2) OPTIONAL Solid State Switch – The RES12VLAB has two secondary solid state switches that can be used to activate lane

lights or other devices.

a) Left/Yellow lane [diagram #3] - When the Receiver's Yellow LED is on, the yellow wire is shorted to ground.

b) Right/Red lane [diagram #4] - When the Receiver's Red LED is on, the orange wire is shorted to ground.

TRANSMITTER

1) Turn on the Transmitter by flipping the toggle switch. It will communicate with the Reciever and display a status:

a) Green LED = Receiver in RUN position

b) Red LED = Receiver in OFF position

c) Yellow LED = Transmitter CANNOT CONNECT to the Receiver.

i) Either the receiver is turned off (Check on/off switch on Receiver or check the connection and ensure black and red

wire are connected to the 12 volt battery)

ii) or the receiver is out of range (Move closer and press either the run button or off button until you receive a solid Green

or Red light. Once the light turns from yellow to either solid red or green you are now at the maximum range. Make a note

of this distance.).

iii) Blinking - Transmitter is sending command to Receiver

2) Press the Red button on the Transmitter. Once the OFF signal has been received by the Receiver, the Red LED on the Transmitter

will illuminate. The engine should now be disabled.

a) The Receiver will show a blinking LED: Blue, Red or Yellow depending on the lane selection switch.

3) Press the Green button on the Transmitter. Once the RUN signal has been received by the Receiver, the Green LED on the

Transmitter will illuminate. The engine should now be enabled.

a) The Receiver will show a sold (non-blinking) light: Blue, Red or Yellow depending on the lane selection switch

4) Test the system again at low speed to understand how the system operates. Engine power will be disabled when the Red button is

pressed within range of the vehicle.

engine.

The RES12VLAB will not slow down or stop the vehicle. The RES only disables the

9/30/19

Firmware ver:6.1.19