Aquatec Aquapro AS10000DF Kullanım Kılavuzu - Sayfa 3

Su Pompası Aquatec Aquapro AS10000DF için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Aquatec Aquapro AS10000DF 6 sayfaları. Submersible sump pump

Sayfayı Yazdır

B. Manual Mode

Caution: The pump is to be observed at all

times during manual mode. Prolonged

use in manual mode may result in a

shorter motor life or burnout. Set the float

switch cable into the circular groove with

the float as close to the pump as

possible. To turn on, position the float

above horizontal. The pump will now run

continuously until turned off. Turn off by

tilting the float down 30° or switching off

at the power point (GPO).

oPERAtIon

The pump is now ready for use; ensure the

pump is not immersed in water deeper than

7m and that the discharge point is not higher

than 7m above the water surface.

2. Ensure the area being pumped out is large

enough to allow the float switch to move

freely and function effectively.

3. Place the pump on a flat surface and check

there are no obstructions to the suction base.

4. When the float switch is 30° higher than

horizontal or above the handle, the pump will

turn on and operate. ATTENTION: The pump

starts up as soon as the float switch reaches

start-up level. ie: Above the handle or higher

than 30°.

5. The pump will turn off when the opposite to

point 4. occurs. ie: The float switch is lower

than the handle or is lower than 30° from

horizontal. Alternatively, you can manually

turn the pump off at the mains power.

6. If you wish to use the pump down to the

minimum water depth of 50mm, the float

switch will need to be operated manually. The

pump can be manually turned "on" by lifting

the float to activate the internal switch.

NB: If you manually turn the pump off, be aware

of the location of your hose or tube. If it is at

a lower point than the pump, the water will

continue to siphon out, unless a non-return valve

(not included) is fitted to the hose or tube.

Turning On and Off

Insert the plug into the mains power socket

(GPO). Avoid using extension cords as this

can lead to a voltage drop which may cause

power loss and overheating.

2. Switch on the mains power to commence

operation.

3. To cease operation, turn off the mains power.

The pump will also stop automatically once

the float switch reaches 30° below horizontal.

Hints for Operation

• To maximise pump flow use the largest

diameter hose or tube possible. Smaller

diameter hose or tube will reduce the flow

rate relative to their size. Where possible use

discharge pipes having a larger diameter than

the discharge outlet.

• Do not run the pump without water flowing

through it. This leads to increased wear and

possible burn out. Immediately unplug the

pump as soon as water supply or flow stops.

NB: The built in thermal overload protector will

automatically switch off the pump in the event of

overheating. The motor automatically switches

back on once cooled down.

MAIntEnAnCE

The pump does not require any maintenance

under normal operating conditions.

Disconnect from electrical power supply before

performing any maintenance procedures.

Cleaning the Pump Housing

Use a damp cloth to clean the outside of pump

housing. Allow to dry thoroughly before storing in

a dry location that is protected from the elements.

Cleaning the Suction Base

Hose down gently with low pressure water. Allow

to dry thoroughly before storing.

Power Cable

For all submersible pumps, a H07RN-F cable is

required. Damage to, and tampering with the

cable voids warranty.