Aquatec SWP-4000 Kullanıcı El Kitabı - Sayfa 5
Su Pompası Aquatec SWP-4000 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Aquatec SWP-4000 12 sayfaları. Swp series solar electric submersible pump d.c. powered
Sayfayı YazdırDischarge line The hose or pipe should be pressure rated for 150 psi. If using rigid drop pipe for the discharge line it is
recommended to use a length of 6 in. flexible hose to connect to the pump outlet fitting secured with a stainless steel
clamp. Then, to the other end of the short 6 in. hose connect a ½" NPT x ½"Barb fitting secured with another stainless
steel clamp. If using flexible discharge tubing you may connect directly to the dual size stainless steel outlet nipple
which fits ½" hose barb tubing ( 0.50 inch ID) or ½" Poly pipe (.62 inch ID, which is equivalent to 5/8" hose barb tubing).
(see figure1). To determine total dynamic head/delivery see chart . (fig. 2) Use no larger than ¾" drop pipe.
Safety line: Install safety line (for lowering and retrieving pump) through the pump eye bolt. Band the Safety line, hose
and electrical cable together with tie wraps every 10 feet to prevent damage to lines when installing the pump.
(see fig. 2) Tie the safety line to a secure point and use this line to lower or raise the pump, in order to not cause
excessive stretch to the pump cable or delivery pipe.
1. Lay out the assembly components on a clean ground surface and begin assembly. Connect the drop pipe or
hose to the pump outlet fitting. See fig. 1.
2. Using a submersible splice kit make a water tight splice joining the drop cable to the pump lead wires. See
details on page .
3. Connect the safety line to eye bolt on the pump.
4. Band all of the above items together as shown in fig.2.
5. If used in a well that has high sand content, a sand shroud may be necessary to prevent pump damage.
6. Lower the assembly into the well.
7. Install check valves every 100 feet of vertical elevation to relieve pressure on the internal pump components.
8. Tie off the safety line to a secure point.
9. A sand filter sock is required if the pump is drawing from a source containing sand/silt/mud. ( ie. Pond,creek,
bottom of tank, etc.) Excessive mud, sand, silt may damage the diaphragm and could void the warranty.
10. When used in an open-source application (see fig. 3), placement in a container such as a bucket or barrel can
help isolate the pump from sediment.
AQUATEC IMI-160, REV C, ECO# 6511, 3/16/15
PUMP INSTALLATION IN WELL
PAGE 5 OF 12