Diamond Guitar Pedals MEMORY LANE Kullanıcı Kılavuzu - Sayfa 5

Müzik Pedalı Diamond Guitar Pedals MEMORY LANE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Diamond Guitar Pedals MEMORY LANE 16 sayfaları.

Sayfayı Yazdır

on. Delay and modulation states can still be changed using the right foot-

switch even when the audio path is in bypass.

Tap/Mod Feature Switch

This small toggle switch situated between the Feedback level and Modulation

depth controls sets the Memory Lane into one of two primary operational

modes:

Tap: delay times are set by footswitch tapping, and the delay time knob

is bypassed. Modulation can still be turned on using the Modulation

depth and speed controls, but the effect is not as pronounced as in

Modulation mode.

Mod: delay times are set by the delay time knob, and modulation, once

set on the Modulation depth and speed controls, can be turned

on and off by the right footswitch. A red right LED indicates that

Modulation is footswitched on in this mode.

Tap/Mod Footswitch

The operation of this footswitch is dependent on the current operational mode

as set by the Tap/Mod feature switch described above.

Tap: In Tap mode, this footswitch sets delay time, with every 2

the switch setting a new tempo. This is a bit different than most

digital delays, where each tap measures the time from the last tap.

On the Memory Lane, every tempo tap should be done in two's – the

ﬁrst tap begins a new measure of tempo, the second completes the

measure and sets the new tempo. The tempo only changes when the

2nd tap is complete. If time between the 1

the maximum delay time, the Memory Lane simply sets the delay

time to maximum on the 2

Mod: In Mod mode, this footswitch toggles on and off whatever modula-

tion setting is currently set on the mod depth and speed controls,

with the right LED toggling between green (off) and red (on). If

the master mod depth control is switched off, toggling the mod

footswitch will have no effect on sound even though the green and

red LED's will toggle.

Input Level Jumper (internal)

This internal jumper is factory set to provide optimum signal-to-noise ratios

through the delay path (in particular the NE570N compandor chip which was

originally designed for relatively quiet telephone signal levels) for typical FX

loop and/or humbucker pickup levels. For extremely hot pickups or FX loops,

this jumper can be set to its alternate position to pad down levels in the delay

path.

Setting Up

The Memory Lane can be used in several different effect conﬁgurations. With

the exception of reverb, delay should probably be the ﬁnal effect in your ef-

fect chain. For channel switching amps, you'll also probably want to place the

delay within the amp's effect (FX) loop if available. This will properly place the

delay after any higher gain distortion stages.

tap.

- 5 -

and 2

taps exceeds

tap on