Aquatec ocean e-vip Kullanım Talimatları Kılavuzu - Sayfa 7

Hareketlilik Yardımı Aquatec ocean e-vip için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Aquatec ocean e-vip 16 sayfaları.

Sayfayı Yazdır
Never store the product directly next to heat
sources.
Never expose the product to direct sunlight.
2.3

Instructions on the battery and charger

Never throw the battery box into a fire. Do
not store it near naked flames.
Do not open the battery box. The warranty
expires if it is opened!
Use only the charger provided to recharge
the rechargeable battery in the battery box.
Recharge the battery in the battery box as
soon as possible after use.
To preserve the service life of the battery
when not in use for prolonged periods,
please observe the instructions in
section 7.3.
Only plug the charger into the mains when
the battery box is connected to the charger.
Except when charging the rechargeable bat-
tery, the battery box socket must always be
sealed with the cap.
3

Description

3.1

Scope of delivery

The AQUATEC E-VIP is supplied with the following
parts (fig. 1):
1
Head support
2
Operating instructions
3
Chest belt
4
Seat plate
5
Pins (4 x), safety clips (4 x), clips for footrests
(2 x), cable tie (1 x) packed in a bag
6
Footrests with heel loops (2 x)
7
Frame with hand control and control box with bat-
tery box and drive mechanisms
8
Seat frame with backrest cover and armrests
9
Charger
10 Drive for tilt adjustment
16
3.2

Technical data

Dimensions
Width
Depth
Height (without head support)
Seat width
Seat depth
Seat height
Min. distance between floor
and holder for the sanitary pan
Dimensions
Weight
Load capacity
Performance data
Operating voltage
Rated current
Rechargeable battery type
Charger input
Charger output
Charge time as from
low-voltage warning
Protection ratings
Commode
Charger
The label (fig. 16) provides important information.
The label is attached to the left rear side of the side
bar.
4

Transport

You can easily disassemble the commode into its com-
ponent parts (section 3.1) for transport.
To disassemble the device, follow the assembly steps
described in section 5 in reverse order.
5

Setting up

Important!
●
Before setting up, inspect all parts for dam-
age during transport.
●
This section describes the assembly. Disas-
sembly is carried out in reverse order.
●
During assembly, make sure the parts are
positioned correctly in relation to each other
(fig. 1).
730 mm
1,010 mm
1,070-1,620 mm
480 mm
450 mm
500-1,050 mm
420-970 mm
approx. 39 kg
150 kg
24 V
8 A
Lead-acid
230-240 V AC, 50-60 Hz
24 V DC, 12 VA
approx. 5-6 h
IP 66 W
IP 40
EN