Diamond H2O Reliant DRS4-EM-66 Manuel - Sayfa 11
Su Sebili Diamond H2O Reliant DRS4-EM-66 için çevrimiçi göz atın veya pdf Manuel indirin. Diamond H2O Reliant DRS4-EM-66 19 sayfaları. Reliant drs4 series single tank water softener
Sayfayı Yazdır- 1. Table of Contents
- 2. Place the Tanks Near a Water Source
- 3. Setting up the Tank
- 4. Connect the Brine Tank
- 5. Connect the Valves to the Water Source
- 6. Electrical
- 7. Start up the System for the First Time
- 8. Bypass Valve Operations
- 9. Main Operating States
- 10. Program the Valve
- 11. Troubleshooting
- 12. System Specifications
- 13. Error Codes
power on reset routine if the initial setting (resin volume) is "no setting". The initial setting can
be cleared in the Program and Data Display State.
E. Program and Data Display
The program and data display state consists of several routines that allow for setting and
displaying programmable values.
F. In Service
The in service state uses several routines that handle the monitoring and display function while
the valve is in service.
G. Regenerating
The regenerating routine handles the operation of the motor to position the cam in various
positions as needed to perform regeneration of the resin bed.
11. Program the Valve
All of the parameters on the valve can be displayed on the LCD Display. Use the Down Key and
Up Keys to navigate through the parameters. Each parameter can be edited by pressing the
Set Key. After the value has been changed, the value can be saved by pressing the Set Key
again. Most of the parameters have already been set by Diamond H
are shown in Table 2, 3 and 4.
LCD Display
Down Key
Set Key
Figure 18: Key Pad and LCD Display
O. All of the parameters
2
Regeneration Key
Up Key
pg. 10