HP 1910-8-PoE+ Veri Sayfası - Sayfa 11

Anahtar HP 1910-8-PoE+ için çevrimiçi göz atın veya pdf Veri Sayfası indirin. HP 1910-8-PoE+ 16 sayfaları. 1910 switch series
Ayrıca HP 1910-8-PoE+ için: Quickspecs (43 sayfalar), Quickspecs (44 sayfalar), Başlangıç Kılavuzu (26 sayfalar)

Sayfayı Yazdır

HP 1910 Switch Series

Specifications (continued)

HP 1910-8G-PoE+ (65W) Switch (JG349A)

Ports

8 RJ-45 auto-negotiating 10/100/1000 PoE+ ports (IEEE

802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX,

IEEE 802.3ab Type 1000BASE-T, IEEE 802.3af PoE, IEEE

802.3at)

1 SFP 1000 Mbps port

1 RJ-45 console port to access limited CLI port

Supports a maximum of 8 autosensing 10/100/1000

ports plus 1 1000BASE-X SFP ports, or a combination

Physical characteristics

10.24(w) x 11.81(d) x 1.72(h) in (26 x 30 x 4.36 cm) (1U

height)

Weight

6.61 lb (3 kg)

Memory and processor

ARM @ 333 MHz, 128 MB flash, 128 MB RAM; packet

buffer size: 512 KB

Mounting

Mounts in an EIA standard 19-inch telco rack or

equipment cabinet (hardware included)

Performance

100 Mb Latency

< 5 µs

1000 Mb Latency

< 5 µs

Throughput

up to 13.4 Mpps (64-byte packets)

Routing/Switching capacity

18 Gb/s

Routing table size

32 entries (IPv4), 32 entries (IPv6)

MAC address table size

8192 entries

Environment

Operating temperature

32°F to 113°F (0°C to 45°C)

Operating relative humidity

10% to 90%, noncondensing

Nonoperating/Storage temperature

-40°F to 158°F (-40°C to 70°C)

Nonoperating/Storage relative humidity 10% to 95%, noncondensing

Electrical characteristics

Frequency

50/60 Hz

Voltage

100-240 VAC

Maximum power rating

93 W

PoE power

65 W

Notes

Maximum power rating and maximum heat dissipation

are the worst-case theoretical maximum numbers

provided for planning the infrastructure with fully

loaded PoE (if equipped), 100% traffic, all ports plugged

in, and all modules populated.

PoE power is the power supplied by the internal power

supply. It is dependent on the type and quantity of

power supplies.

Safety

UL 60950; IEC 60950-1; EN 60950-1; CAN/CSA-C22.2 No.

60950-1-03

Emissions

FCC part 15 Class A; VCCI Class A; EN 55022 Class A;

CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,

61000-3-3; ICES-003 Class A

Management

IMC - Intelligent Management Center; limited

command-line interface; Web browser; SNMP Manager;

IEEE 802.3 Ethernet MIB

Notes

SFP port and copper ports work simultaneously,

independent of each other, to provide a total of 9 Gigabit

Ethernet-capable ports.

HP 1910-8G-PoE+ (180W) Switch (JG350A)

8 RJ-45 auto-negotiating 10/100/1000 PoE+ ports (IEEE

802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX,

IEEE 802.3ab Type 1000BASE-T, IEEE 802.3af PoE, IEEE

802.3at)

1 SFP 1000 Mbps port

1 RJ-45 console port to access limited CLI port

Supports a maximum of 8 autosensing 10/100/1000

ports plus 1 1000BASE-X SFP ports, or a combination

10.24(w) x 11.81(d) x 1.72(h) in (26 x 30 x 4.36 cm) (1U

height)

6.61 lb (3 kg)

ARM @ 333 MHz, 128 MB flash, 128 MB RAM; packet

buffer size: 512 KB

Mounts in an EIA standard 19-inch telco rack or

equipment cabinet (hardware included)

< 5 µs

up to 13.4 Mpps (64-byte packets)

18 Gb/s

32 entries (IPv4), 32 entries (IPv6)

8192 entries

32°F to 113°F (0°C to 45°C)

10% to 90%, noncondensing

-40°F to 158°F (-40°C to 70°C)

10% to 95%, noncondensing

50/60 Hz

100-240 VAC

228 W

180 W

Maximum power rating and maximum heat dissipation

are the worst-case theoretical maximum numbers

provided for planning the infrastructure with fully

loaded PoE (if equipped), 100% traffic, all ports plugged

in, and all modules populated.

PoE power is the power supplied by the internal power

supply. It is dependent on the type and quantity of

power supplies.

UL 60950; IEC 60950-1; EN 60950-1; CAN/CSA-C22.2 No.

60950-1-03

FCC part 15 Class A; VCCI Class A; EN 55022 Class A;

CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,

61000-3-3; ICES-003 Class A

IMC - Intelligent Management Center; limited

command-line interface; Web browser; SNMP Manager;

IEEE 802.3 Ethernet MIB

SFP port and copper ports work simultaneously,

independent of each other, to provide a total of 9 Gigabit

Ethernet-capable ports.

HP 1910-24 Switch (JG538A)

24 RJ-45 autosensing 10/100 ports (IEEE 802.3 Type

10BASE-T, IEEE 802.3u Type 100BASE-TX); Duplex: half

or full

2 SFP dual-personality 1000 Mbps ports (IEEE 802.3ab

Type 1000BASE-T)

1 RJ-45 console port to access limited CLI port

Supports a maximum of 24 autosensing 10/100 ports

plus 2 1000BASE-X SFP ports, with optional module

17.32(w) x 6.81(d) x 1.73(h) in (44 x 17.3 x 4.4 cm) (1U

height)

4.85 lb (2.2 kg)

MIPS @ 500 MHz, 32 MB flash, 128 MB RAM; packet

buffer size: 512 KB

Mounts in an EIA standard 19-inch telco rack or

equipment cabinet (hardware included)

< 5 µs

up to 6.6 Mpps (64-byte packets)

8.8 Gb/s

32 entries (IPv4), 32 entries (IPv6)

8192 entries

32°F to 104°F (0°C to 40°C)

10% to 90%, noncondensing

-40°F to 158°F (-40°C to 70°C)

10% to 95%, noncondensing

50/60 Hz

100-240 VAC

12 W

Maximum power rating and maximum heat dissipation

are the worst-case theoretical maximum numbers

provided for planning the infrastructure with fully

loaded PoE (if equipped), 100% traffic, all ports plugged

in, and all modules populated.

IEC 60950-1; EN 60950-1; UL 60950-1 2nd Edition; CSA

C22.2 No. 60950-1-07 2nd Edition

FCC part 15 Class A; VCCI Class A; EN 55022 Class A;

CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,

61000-3-3; ICES-003 Class A

IMC - Intelligent Management Center; limited

command-line interface; Web browser; SNMP Manager;

IEEE 802.3 Ethernet MIB

The HP 1910-24G Switch (JE006A) was formerly sold as

the 3Com Baseline Plus 2928 (3CRBSG2893) and may

ship with this product labeling.

SFP ports and copper ports can work simultaneously,

independent of each other, to provide a total of 28

Gigabit Ethernet-capable ports.