HP 3100-48 v2 Kurulum Kılavuzu - Sayfa 12
Anahtar HP 3100-48 v2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. HP 3100-48 v2 47 sayfaları.
Sayfayı Yazdır
1.
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2.
Check that the mounting brackets have been securely attached to the switch chassis.
3.
Install cage nuts (user-spplied) in the mounting holes in the rack posts.
4.
One person holds the switch chassis and aligns the mounting brackets with the mounting holes in
the rack posts, and the other person fixes the mounting brackets with anti-rust screws (user-supplied)
to the rack.
5.
Check that the switch chassis is horizontal and tighten the screws.
Figure 8 Mount a 3100-48 v2 switch in a rack
Mounting the switch on a workbench
If a standard 19-inch rack is not available, you can place a 3100-48 v2 switch on a clean, flat workbench,
as follows:
1.
Check that the workbench is sturdy and well grounded.
2.
Place the switch with bottom up, and clean the round holes in the chassis bottom with dry cloth.
3.
Attach the rubber feet to the four round holes in the chassis bottom.
4.
Place the switch with upside up on the workbench.
8