HP 316095-B21 - StorageWorks Edge Switch 2/24 Yayın Notu - Sayfa 17

Anahtar HP 316095-B21 - StorageWorks Edge Switch 2/24 için çevrimiçi göz atın veya pdf Yayın Notu indirin. HP 316095-B21 - StorageWorks Edge Switch 2/24 23 sayfaları. Edge switch release notes
Ayrıca HP 316095-B21 - StorageWorks Edge Switch 2/24 için: Güncelleme Kılavuzu (9 sayfalar), Manuel (41 sayfalar), Manuel (40 sayfalar), Yayın Notu (32 sayfalar), Yayın Notu (27 sayfalar), Manuel (26 sayfalar), Yayın Notu (27 sayfalar), Yayın Notu (25 sayfalar), Kurulum Talimatları Kılavuzu (24 sayfalar), Yayın Notu (23 sayfalar), Yayın Notu (23 sayfalar), Yayın Notu (22 sayfalar), Yayın Notu (19 sayfalar), Yayın Notu (19 sayfalar), Yayın Notu (18 sayfalar), Talimatlar Kılavuzu (17 sayfalar), Yayın Notu (17 sayfalar), Yükseltme Talimatları (16 sayfalar), Talimatlar Kılavuzu (16 sayfalar), Kurulum Talimatları Kılavuzu (16 sayfalar), Yayın Notu (16 sayfalar), Yayın Notu (17 sayfalar), Yayın Notu (17 sayfalar), Yayın Notu (11 sayfalar)

Erroneous message from save/restore configuration

An erroneous message, "Warning: Switch IP ACL list will not be enabled because host IP Address is

not found in the list", is issued while doing save/restore configuration with IP access control list (ACL)

state enabled. This message can be ignored as restore happens successfully.

Firmware installation error if zoneset activation not completed

An error indication on firmware installation: "Cannot install firmware. Fabric configuration management

operation in progress", can be encountered if a very large zone set, particularly with NPIV members,

is activated just prior to firmware installation. This can occur when the zoneset activation is not yet

completed before the firmware installation is started. To avoid this, do not schedule firmware installation

at the same time as activation of large zonesets. If encountered, wait until the zoneset activation is

completed and proceed with firmware installation.

Erroneous event reason code reported

If Port is disabled (blocked) due to meeting the threshold criteria defined in the port fencing policy

with FL Loop Device in M4700,M4400, or Edge Switch 2/24 (Sphereon 4500), and results in an

Event 82 being reported, the reason code in the event may be incorrect.

SNMP object returns incorrect value

The SNMP object t11NsInfoSubsetTableLastChange does not return the proper value of the

last change in the Name Server timestamp, but instead returns the value 0 days

00h:00m:00s.00th.

Syslog client may not show IPv6 address

If a server configured to receive syslog messages has both IPv6 and IPv4 addresses configured, the

"Source IP" shown by the syslog client on the server may only be the IPv4 address even though the

switch is opened using IPv6 address.

Event may be logged more frequently than expected

If there are short and medium CIDR (Continuous Incident Detection and Reporting) events, they are

reported every 3 hours where they should be reported every 24 hours, so there could be more of

these types of event appearing in the Event log than would normally be expected.

Director and Edge Switch release notes (09.08.03)