HP 5300 İnceleme El Kitabı - Sayfa 19

Anahtar HP 5300 için çevrimiçi göz atın veya pdf İnceleme El Kitabı indirin. HP 5300 35 sayfaları. Hp compaq presario,presario 5300: supplementary guide
Ayrıca HP 5300 için: Tamamlayıcı Kılavuz (7 sayfalar)

Sayfayı Yazdır

2.4.5 End-to-End QoS

QoS capabilities in the switch allow it to deal with two different concerns that arise in Ethernet

networks: congestion control and latency. In the past, controlling traffic congestion was viewed as the

primary reason for QoS. But with Ethernet prices dropping substantially year after year it has been

easier and lower cost to deal with congestion, at least in the local LAN, by increasing the bandwidth

available to traffic through higher speed connections.

While QoS for congestion control in the local LAN has had marginal value, the ability of QoS to deal

with applications that are sensitive to varying latencies through a network is of value. Delay sensitive

applications depend on isochronous, or time-dependent, data. Applications of this type include VoIP,

streaming voice or video, data storage backups, or network control in the form of SNMP packets,

Spanning Tree BDPU packets, etc.

When trying to make overall packet latency as low as possible or minimize latency jitter, end-to-end

control becomes important. The 802.1p priority specification that is contained in each tagged packet,

as well as the DSCP, can provide this end-to-end continuity. As the packet travels from source to

destination, it is given the proper priority in each switch it travels through based on its 802.1p value.

The HP ProCurve Switch 5300xl Series maintain the 802.1p tags across routed interfaces, allowing end-

to-end QoS in routed environments.

The DSCP can also be used for QoS categorization of the packet. The HP ProCurve Switch 5300xl

Series can assign priorities based on the DSCP. Packets that are not 802.1p tagged can nonetheless

have a priority assigned to them through the DSCP alone.

The ability of the HP ProCurve Switch 5300xl Series to control not only the 802.1p priority, but also

read and/or re-write the DSCP bits to set QoS policy provides the network manager with an even finer

degree of control. Priority can be tailored to specific areas of the network, and the DSCPs can be used

eventually for parts of QoS policy other than priority. There is also room in the DSCP definition for

new QoS services that have not yet been defined.

2.5 Security

2.5.1 Filtering

2.5.1.1 ACLs – Access Control Lists

When routing is turned on across Layer 3 interfaces, all routable packets are allowed across these

interfaces. Selectively filtering the packets that can flow across these interfaces is useful for security or

bandwidth control purposes. Filtering at Layer 3 is done through ACLs, Access Control Lists.

A single complete filter statement, the ACL, is comprised of one or more ACEs, Access Control Entries.

An ACE statement can permit or deny a packet based on it's:

•

Source and/or destination IP address or IP subnet

•

Source and/or destination TCP/UDP port number with less than, greater than, equal, not equal

or number range. Being able to specify less than, greater than, etc. can save a lot of ACEs trying

to bound a group of port numbers and is not found in some competitors' ACL implementations.

•

IP protocol (IP, TCP, UDP)

Each static VLAN on the 5300 can have one inbound and one outbound ACL defined. The 5300 can have

up to 99 Standard ACLs, which are defined as ACLs that are based only on source IP addresses. The

5300 can also have up to 99 Extended ACLs, which are defined as ACLs based on any of the other

parameters listed above. Up to a total of 1024 ACEs can be used to specify the 5300 ACLs.

The order of the ACEs within the ACL is important. When processing an ACL, the 5300 starts with the

first ACE in the ACL and will continue to work through the list of ACEs, in order, until the packet

matches the condition set forth in a particular ACE. At that point any further ACEs in the ACL are

HP ProCurve Switch 5300xl Series Reviewer's Guide

Rev 1.1 – 2/11/2003

http://www.hp.com/go/hpprocurve

Page 19 of 35