AQUATECH Elite Sport Kullanım Kılavuzu - Sayfa 5

Kamera Aksesuarları AQUATECH Elite Sport için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AQUATECH Elite Sport 6 sayfaları. Housing

Securing The Housing

Before every use please follow these steps to

make sure your Sport Housing has a watertight

seal. When you first receive your gear we

recommend that you do these steps without

the camera and lens inside the Sport Housing:

1. Ensure O-rings are present and in the

assigned grooves.

2. Attach the Camera Plate to the bottom

of your camera and slide it into the Sport

Housings Manny Mount.

3. With the Sport Housing facing downward

put your Back Plate on and lay the four Clips

over the metal Back Plate Strikes on each

corner. Without clamping down the clips you

will notice that you have the ability to shift

the Back Plate around in order to line up the

buttons.

4. Once the buttons are positioned over the

cameras controls correctly you can then clamp

down the Clips. Make sure to clamp them down

two at a time corner to corner.

5. Check the Main O-ring to ensure that you

have a nice seal all around and that the Main

O-ring is not pinched.

6. You will notice a Flap on the clip when it

is clamped down. If the clip is not clamped

down correctly that flap will not be noticeable.

The important final check with the clip is to

pull up against it to make sure it does not

come undone and is locked. The Flap being up

indicates the Safety latch is engaged.

7. Screw your Lens Port onto the Sport Housing.

Your Port should screw on with ease and

never feel as if it is being forced. Ensure the

thread on the base of your Port and the Front

of the housing are aligned. Tighten the port

to hand tight making sure not to pinch the

Compression O-ring.