AQUATECH ECO 3600 Kullanıcı Talimatları - Sayfa 8

Su Pompası AQUATECH ECO 3600 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. AQUATECH ECO 3600 12 sayfaları. Eco pond series

Optimal use of water flow:

Regulator Extern suction

Optimal use of suction:

The extern suction of the Eco pumps can easily be adjusted from 0 - 100% by the regu-

lator bottom, i.e. at a setting of 0% the pump draws only from the housing and at a

setting of f. ex. 50%, the pump draws ca. 50% from the housing and ca. 50% from the

extern suction.

The extern suction can with big advantage be connected to a surface skimmer or a fil-

ter, which can be placed in the pond, so that the necessary service and cleaning of the

pre-filter housing is easy to proceed.

If you connect a surface skimmer, it is important that the skimmer does not pass dirt

particles bigger that 8 mm, otherwise the impeller can block and that could damage the

pump.

Also a surface skimmer with pre-filter can be connected, but that requires the installa-

tion of an adjustable Y-distributor in the pond, so that it is possible to adjust between

the suction from the skimmer and the suction from the pre-filter or low water filter.

For getting the optimal flow out of your

ECO pump, you have to use either the ver-

tical or the horizontal connection and the

ball-joint swivels maximum 15º.

NB: If the ball-joint swivels like shown on

these photos you will experience a flow

loss of up to 30 % and that can be avoided

easily by choosing the right pump outlet.

Always remember to choose the biggest

possible hose diameter, as a to little hose

can reduce the possibility to yield the opti-

mal flow and the result could be a consid-

erable loss of capacity.

Important!

The pump may not run dry, as the mo-

tor could be damaged as a result and

the bearings and the ceramic shaft

could break down.

Never use the pump in the pond with-

out housing (pre-filter housing). Ensure

that the hose is not bended, so that the

water flow does not block.

When the pump is in use, you have to

maintain (clean) it regularly, depending

on the pollution level of the water, for

ensuring the optimal operation.