AQUATECH CAN165-300 Kullanım Kılavuzu - Sayfa 10
Su Sebili AQUATECH CAN165-300 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AQUATECH CAN165-300 16 sayfaları. 165 series
Sayfayı Yazdır- 1. Table of Contents
- 2. Water Softener Gallon Setting Chart
- 3. System Specifications
- 4. Programming
- 5. General System Installation
- 6. System Configuration
- 7. Maintenance
- 8. Power Head Valve Exploded View
- 9. Power Head Parts List
- 10. Control Valve Exploded View
- 11. Control Valve Parts List
- 12. Trouble Shooting
Maintenance
Adding Salt
Use only crystal water softener salt. Check the salt level monthly. It is important to maintain the salt level
above the water level. To add salt, simply lift the salt lid and add the salt directly into the brine tank. Be
sure the brine well cover is on and fill only to the height of the brine well.
Bridging
Humidity or wrong type of salt may create a cavity between the water and the salt. This action, known as
"bridging", prevents the brine solution from being made, leading to your water supply being hard.
If you suspect salt bridging, carefully pound on the outside of the brine tank or pour some warm water
over the salt to break up the bridge. This should always be followed up by allowing the unit to use up any
remaining salt and then thoroughly cleaning out the brine tank. Allow four hours to produce a brine
solution, and then manually regenerate the softener.
Care of Your
Softener
To retain the attractive appearance of your new water softener, clean occasionally with mild soap
solution. Do not use abrasive cleaners, ammonia or solvents. Never subject your softener to freezing or to
temperatures above 120°F.
Cleaning the
Injector Assembly
Sediment, salt and silt will restrict or clog the injector. A clean water supply and pure salt will prevent this
from happening.
The injector assembly is located on the right side of the control valve. This assembly is easy to clean.
Shut off the water supply to your softener and reduce the pressure by opening a cold soft water faucet.
Using a screwdriver, remove the two screws holding the injector cover to the control valve body. Carefully
remove the assembly and disassemble as shown in Figure 6. The injector orifice is removed from the valve
body by carefully turning it out with a large screwdriver. Remove the injector throat the same way.
Carefully flush all parts including the screen. Use a mild acid such as vinegar or Pro-Rust Out to clean the
small holes in the orifice and throat.
Re-assemble using the reverse procedure.
Resin Cleaner
An approved resin cleaner must be used on a regular basis if your water supply contains iron. The amount
of resin cleaner and frequency of use is determined by the quantity of iron in your water (consult your
local representative or follow the directions on the resin package).
Figure 12. Injector Assembly
10